7-Way Trailer Wiring Extension Recommendation
Published 10/13/2015
Question:
I just want to make an extension for a 7 blade RV connector. The trailer end is fine, round and smooth. Does ANYONE make a plain vehicle end with NO mounting brackets ect. ? Thanks,
asked by: L.K.
0
Expert Reply:
Based on what you said it sounds like you are looking for a 7-way extension like part # 20027. This is a 7 foot section that has a male 7-way on one end a 7-way female on the other.
The female connector does have a mounting plate attached to it though and there really isn't a way around that.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
- Custom Fit Vehicle Wiring
- 5th Wheel and Gooseneck Wiring
- Vehicle End Connector
- Universal Fit
- 7 Blade
- Plug and Lead
- Plug-In
- Draw-Tite
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Extension For 7-way Plug On Trailer To Allow 7-Way Bumper Connection Use
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: How Much Do the Rock Tamers Heavy-Duty, Adjustable Mud Flap System for 2" Hitches Weigh?
- Q&A: Comparing the Curt A20 and B&W Companion 5th Wheel Hitches Jaw Systems
- Q&A: Spare Wheel and Tire for Aluma Trailer 6310H
- Q&A: Replacement For Grease Seal 32374 For Trailer
- Article: Trailer Lighting Requirements
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: The Best 5th Wheel Hitches