Is Resistor Needed to Install Optronics LED RV Interior Lamp
Updated 09/28/2015 | Published 09/26/2015
Question:
Can i hook these directly up to a 12 volt battery system, or do they need a resister? If so do you sell the resister that goes with it?
asked by: Richard
1
Helpful Expert Reply:
The Optronics LED RV Interior lamp you mentioned, part # RVILL33 can indeed be installed directly to 12 volt power. The lamp has two wires, the black wire connects to a 12 volt power source, the white to ground. No resistor is necessary.
Optronics offers a lifetime warranty on the LED's.
expert reply by:
Mike L
1
Product Page this Question was Asked From
Optronics 12V LED RV Dome Light - Single - 6-3/8" Long x 4-3/16" Wide - White Housing
- RV Interior Lights
- Dome Light
- Warm White
- On/Off Switch
- Surface Mount
- LED Light
- 12V
- White
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Connector for a Pollak PA66-MD40
- Q&A: Looking For Trailer Jack With 1-3/4" Tube Diameter
- Q&A: Replacement Air Filter for GE RV AC Unit
- Q&A: What is the Difference Between the Tekonsha Prodigy P2 and the P3 Brake Controllers
- Q&A: Replacement Glass Shade for the Gustafson RV Ceiling Light # 277-000330-331
- Q&A: Braking and Electrical Parts Needed to Flat Tow a 2021 Chevrolet Colorado Gas or Diesel
- Q&A: Direct Replacement Water Heater for Atwood Model GC10A-4E
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Can I Put Wallpaper in My RV?
- Article: How to Install E-Track in 3 Easy Steps
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Most Popular Wheel Bearings
- Article: Cargo Tie-Down Methods