Recommended Replacement 3-Step Trailer Step Assembly for 24-Inch Mounting Hole Spacing
Updated 09/23/2015 | Published 09/22/2015
Products Featured in This Question
Question:
I have a two step I would like a three step but my bolt hole center is 24 max total length is 25 12
asked by: Pierre
0
Expert Reply:
We do not offer any pull-out 3-step assemblies that match your mounting hole spacing so to install a new set of pull-out steps like the Flexco Manual Pull-Out Steps # SMFP-3200L you'll just need to drill new mounting holes. I have linked you to all of our 3-step manual step assemblies. You'll want to note the retracted height of the steps you choose to ensure you maintain safe ground clearance.
expert reply by:
Adam R
0
Product Page this Question was Asked From
Flexco Manual Pull-Out Steps for RVs - Triple - 8" Drop/Rise - 24" Wide - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 24 Inch Wide Step
- 27 Inch Wide
- 3 Steps
- 8 Inch Drop/Rise
- 26 Inch Entry
- 27 Inch Entry
- 28 Inch Entry
- 29 Inch Entry
- Steel
- Stromberg Carlson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will Flexco Pull-Out Triple Steps Work With Camper That Measures 31-Inches From Camper To Ground
- Q&A: 3 Step RV Step Replacement Solution for Brackets 25-1/2 inches in Width
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Replacement Axle and Leaf Springs for Trailer With Lippert 3,500 lb Axle
- Q&A: Replacement Fan Motor For Kinmore Vent # RS-385 PHC2-171BVDO218-00
- Q&A: How To Determine The Correct Replacement RV Steps For A 2016 Fleetwood Storm Motorhome
- Q&A: Replacement Bearings, Races, and Seals for a Dexter Number 297697 7K Axle
- Q&A: Can Freezer Fan/Motor Be Replaced on First Gen Everchill Fridge
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: How to Replace a Rubber RV Roof
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com