Can Edge Programmers Allow you to Remove the DPF of Diesel Truck
Published 08/25/2015
Question:
I have a 2011 ram 2500 6.7 cummins crew cab laramie that I currently have Edge CTS3 evolution programmed with it. My question is, if I drop the dpf and run a 4-inch turbo back, will the Edge programmer take care of the computer codes that i will throw. Also will the Edge programmer recognize that the DPF is not there and thus not go in DPF REGEN mode any more.
asked by: Daniel M
Expert Reply:
Edge can not recommend you remove the DPF of your truck as that would violate the emissions laws that are present on newer diesel trucks. Because of that the programmer would not allow you to shut off codes in the computer that relate to removing the DPF. For what you are trying to do you would need to look into a custom tuning hardware and realize that you have made your truck an "offroad only", vehicle.
Product Page this Question was Asked From
Edge Diesel Evolution CTS3 Performance Tuner - Color Screen
- Performance Chip
- Performance Tuners
- With Monitor
- Color Touch Screen
- Yes - California Approved
- Evolution
- Edge
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Can I Use Both the TorkLift StableLoad and the SuperSprings Super Sway Stops for Hauling Camper?
- Q&A: Comparing Pacbrake to Firestone and Air Lift Air Bags
- Q&A: Do I Want Sumo Springs or Timbrens to Pair with My Weight Distribution Hitch?
- Q&A: What Temperature is the Cold Engine Protection Turned Off on a 2003 Dodge Ram with Cummins Engine
- Q&A: Will Edge Juice with Attitude for 2004 Dodge Diesel Work in a 2005 Dodge Diesel?
- Q&A: Where is the Hitch Ball Hole At On 2008 Dodge Ram with B&W Gooseneck Hitch
- Q&A: Compatibility of Edge Diesel Evolution CTS3 Performance Tuner to Ram Diesel