Can the Ramp Spring # RS16933LH Be Installed on a 1-1/4 inch Diameter Pin
Published 08/25/2015
Question:
My equipment trailer has 1 and a quarter inch ramp hinge shaft diameter and I was wondering if I could still use the 1 and a half inch spring on it.?
asked by: Jay
0
Expert Reply:
The inner diameter of the Ramp Spring # RS16933LH that you referenced is 1-1/2 inches, you could easily use this spring on a hinge shaft that is 1-1/4 inches in diameter.
I spoke with my contact at Redline to confirm this.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
1/2" Diameter Greasable Hinge Pin, 4-1/2" Long
- Accessories and Parts
- Trailer Door Hinges
- Trailer Door Parts
- Hinge Pins
- Redline
more information >
Continue Researching
- Q&A: How is Pin of Trailer Barrel Hinge Secured
- Q&A: Is There a Replacement 4-Pin, DPST Rocker Switch
- Q&A: Replacement Motor for Fan-Tastic Roof Vent 5300
- Q&A: Replacement Lid Options For A Dometic FV5300 RV Roof Vent
- Q&A: Where To Mount The TST TPMS Repeater On A 2020 Grech Strada RV
- Q&A: Replacement Hub and Drum With 25580 Inner Bearing and LM67048 Outer Bearing
- Article: Most Popular Wheel Bearings
- Q&A: Replacement Ramp Gate Pin Latch For Carry On Utility Trailer From Tractor Supply