Is Trimming, Drilling, or Modification Needed to Install Trailer Hitch on a 2010 VW CC
Updated 06/02/2010 | Published 05/29/2010
Question:
Please advise what kind of modification/trimming needs to be done for installation. Kindly verify if any exisiting parts needs to be removed prior of installation. Its a 2010 VW CC 2.0T. Thank you for your advice.
asked by: Scott
Expert Reply:
To install the Curt Class I Trailer Hitch Receiver, # C11091, on your 2010 Volkswagen CC, you will have to some minor drilling, trimming, and temporarily lower the exhaust. The trailer hitch bolts on using existing holes on the vehicle frame.
I have included a link to the installation instructions for you so you can see what is involved in the installation. All of the hitches for your CC will require drilling and trimming.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Tail Lights for a 2008 Featherlite 4926 Car Hauler Trailer
- Q&A: Correct 4-Way Wiring Harness for 2025 Kia Sorento Hybrid SX Prestige
- Q&A: What are the Correct Bearings and Races for Dexter 8-201 Electric Drum Brakes?
- Q&A: Replacement Hub For A Trailer With A BT8 Spindle
- Q&A: Replacement Hub for Harbor Freight 4 x 8 Trailer
- Q&A: Bearing Buddy Grease Caps for Hub Bore Dimension of 2.05-Inches
- Q&A: Comparing Trailer Brake Magnets # BP01-225 and # BP01-180