What Size is the Screw Portion of the Leveling Scissor Jack Set, # JSC-30
Updated 06/04/2010 | Published 05/28/2010
Question:
Please tell me if the crank handle is connecting to a 3/4 screw thread head.
asked by: Doug
0
Expert Reply:
I spoke with my contact at Stromberg Carlson and she stated that the Leveling Scissor Jack Set, # JSC-30, uses a 3/4 inch screw to raise and lower the jack. So the included handle would accept that 3/4 inch screw.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Leveling Scissor Jack Set - 30" Lift - 15,000 lbs - QTY 2
- Camper Jacks
- 5th Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Scissor Jacks
- Steel
- 10001 lbs or More
- Manual Jack
- 30 Inch Lift
- Bolt-On
- Weld-On
- 2 Jacks
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Schematic Drawing of etrailer Scissor Stabilizer Jacks
- Q&A: What Do I Need to Build a Custom Lift-Up Side Door on an Enclosed Trailer?
- Q&A: Will etrailer Swivel Jack w/ Bolt-On Mounting Plate Work On Restored Rental Trailer
- Q&A: How to Replace Interior Ram Jack Rod and Nut # TJD-12000-RODNUT on 12000 Series Jacks
- Q&A: Where to Measure on a Scissor Jack to Determine if it Will Fit on a Trailer
- Q&A: Diagram of a 10k Bulldog Landing Gear Jack for Gear Replacement
- Q&A: Best Replacement AC for Dometic Duo Therm 57915.531
- Article: Brake Controller Installation: Starting from Scratch
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Where to Position the Trailer Axle?
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices