Quick Connector 2-Way Availability for Installing a Trolling Motor
Updated 06/24/2015 | Published 06/23/2015
Products Featured in This Question
Question:
do you have a cable connector so i can just connect my minn kota outboard engine trough comfort conectors. so the cable that comes from my engine has a comfort connector at the end. the cables attached to my engine is open eyelet connector. in advance thank you.
asked by: Piet H
Expert Reply:
It sounds like you are looking for an easy to connect and disconnect 2-way wiring connector that you can use to install your trolling motor. If 16 gauge wire is adequate you could use the part # HM47965 for this. You would need to cut the wires in the middle of the harness and then wire each side in the middle of the power and ground wires for the trolling motor.
Product Page this Question was Asked From
CTEK Comfort Connect M6 (6.4-mm) Spare Battery Cable
- Accessories and Parts
- Battery Charger
- Cables
- Spare Battery Cable
- CTEK Power Inc
more information >
Continue Researching
- Q&A: Replacement Puck Light Solution for Sunlink RSBF-4N-008
- Q&A: Replacement Trailer Lighting and Wiring Harness for a Big Tex 70PL Utility Trailer
- Q&A: Faster Charging Cable For A Noco GBX155 Boost X Jump Starter
- Q&A: Replacement Hub And Drums For A Lippert 126003
- Q&A: What Boost Jump Starter Does Eyelet Cable with X-Connect Adapter Work With