Wiring a P2 Brake Controller to Factory Harness on a 2007 Ford Expedition
Updated 05/26/2015 | Published 05/22/2015
Question:
my 2007 Ford Expedition Eddie Bower factory harness has 5 wires: Red - Electric Brakes White - Ground Green - Stop Lamp Brown - Illumination Feed Blue - No Label How do i connect those to the Red, White, Blue and Black from the Prodigy harness?
asked by: Danny D
Helpful Expert Reply:
On the P2 brake controller # 90885 the white wire is ground and will go to the white ground wire on your 2007 Ford Expedition. The brake controller red wire will go to the Ford green wire for input from the brake switch. The brake controller blue wire will go to the Ford red wire for output to the electric trailer brakes.
That just leaves the brake controller black wire which I believe is going to go to that blue wire on the Ford Expedition. It would not use the brown wire since the brake controller black wire is for 12 volt power to the controller. You can use a circuit tester such as # PTW2993 to test that blue wire and if it is hot all the time then it would connect to the brake controller black wire.
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Splice-In
- Under-Dash Box
- Under-Dash
- Up to 4 Axles
- LED Display
- Single Trailer Only
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between the Tekonsha Prodigy P2 and the P3 Brake Controllers
- Q&A: Brake Controller Recommendation for a Truck with Air Brakes and a Trailer with Electric Brakes
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Does the Curt Base Plate Kit Work w/ the Ford Modular Bumper on a 2025 Ford Bronco Everglade?
- Q&A: Towing a Trailer with Electric Brakes with a Semi Tractor with Air Brakes
- Q&A: Brake Controller Wiring for Ford E-450 Motorhome
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Measure for Trailer Hitch Drop