Dimensions of the Timbren Axle-Less system part # A12RS440

Question

Question:

Dear all: I am very interested in the axle of this link: A12RS440 Could you please send the technical draw of it? Please, kinly reply asap. Thank you

asked by: Eduardo P

1

Helpful Expert Reply:

I attached all of the dimensional drawings we have for the Timbren Axle-Less system part # A12RS440 that you referenced.

expert reply by: Jameson C

1

click to enlarge

Answer 1

I can certainly point you in the right direction. I will start by saying that our "rule of thumb" is that we want at least 1" of clearance between the tire and the trailer frame. With the hub face currently at 48", you will want…

view full answer...

Answer 2

The best suspension to add is going to be an axle-less system from Timbren. These are universal fits and I highly recommend checking out the Timbren Axle-Less Trailer Suspension System w Electric Brake Hubs #A35RS545E. This will give you a full…

view full answer...

Answer 3

All of our trailer spindles are shown on the linked page, but none of these has a stub end to fit 2 x 3-inch tubing. All are either round like #TRU74FR or square like #TRU47FR. For a fabrication project like yours a better solution may be a bolt-on…

view full answer...

Answer 4

We do offer the Replacement Trailer Hub Bearing, part #15123 for your trailer but I was unable to find a cross-reference for the Timken 09067 bearing you stated you need. You can measure the inner diameter and see if there are any bearings from the…

view full answer...

Answer 5

To upgrade the axle and hubs on your Northern Hardware Trailer, I recommend looking at an Axle-Less System like the Timbren #A20RS545. This suspension system will provide you with a smooth, quiet, and safe ride and can completely eliminate the need…

view full answer...

Answer 6

I have a replacement option for you, but the only slipper spring we offer that is 1-3/4" wide and is 26-1/4" long is the 4-Leaf Slipper Spring w/ Open Eye End for 4,300-lb Trailer Axles - 26-1/4" Long #e33SR. Since you mentioned that…

view full answer...

Answer 7

What happens to slipper springs is that over time they elongate and flatten out, particularly if your springs are considerably older. The most important measurement you mentioned was the 26 inches from the center of the spring eye to the end of the…

view full answer...

Answer 8

The only differences between the Demco eZ-Latch Couplers #DM37ZR and #DM14793-81 is that the former has integrated loop holes for installing safety chains and a about a 2" drop while the latter doesn't come with provisions for attaching the…

view full answer...

Dimensions of the Timbren Axle-Less system part # A12RS440

Product Page this Question was Asked From

Continue Researching