Purpose of the Included Felt of the Cipa Tow Mirrors part # CM10500
Updated 05/06/2015 | Published 05/05/2015
Products Featured in This Question
Question:
What do I do with the felt strip?
asked by: Bruce
0
Expert Reply:
The felt covered wedge that comes with the Cipa Tow Mirrors part # CM10500 that you referenced is what matches the shape of the mirrors of your vehicle and holds tension in the mirror so that it doesn't slip off. The felt attaches to the wedge to prevent scratching of the mirrors.
The replacement wedges for these mirrors is part # CM10503.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
CIPA Custom Towing Mirrors - Slip On - Driver Side and Passenger Side
- Towing Mirrors
- Slide-On Mirror
- Manual
- Pair of Mirrors
- Custom Fit
- Fits Driver and Passenger Side
- CIPA
more information >
Continue Researching
- Q&A: Are There Custom Towing Mirrors With Electric & Heat For 1999 Dodge Ram 2500
- Q&A: Recommended Towing Mirrors for a 2016 Toyota Tacoma
- Q&A: Recommended Universal Towing Mirrors for 2011 Jeep Wrangler
- Q&A: Will Curt Gooseneck Plate, # 16055, Fit On Reese Rails, # RP30035, And What Is Rating On Rails
- Q&A: Will Coil SumoSprings For 2022 Ford Expedition Reduce Rear Suspension Sag When Towing
- Q&A: Recommended Towing Mirrors for 2002 Dodge 2500
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?