Thread Tap Size Needed to Clean Weldnuts of 2008 Hyundai Elantra for Hitch Install
Published 05/05/2015
Question:
What size thread tap is needed?
asked by: John Y
0
Expert Reply:
In the install video for the Draw Tite hitch part # 24795 that you referenced our installer references using a thread tap to clean out the weld nuts of the 2008 Hyundai Elantra so that the bolt will thread in. The size thread tap you would need would be the same as the size bolts that are used to install the hitch, M12 x 1.25 x 40mm CL8.8.
I attached a couple help articles on cleaning weld nuts for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Which Vehicles Does Draw-Tite Sportframe Trailer Hitch Receiver 24795 Fit
- Q&A: Trailer Hitch for a 2010 Hyundai Elantra Sedan
- Q&A: Trailer Hitch Recommendation for 2008 Hyundai Accent for Ground Clearance
- Q&A: Install Video for Draw Tite Trailer Hitch that Fits 2010 Hyundai Accent
- Q&A: Where Does a Stabilizing Strap Attach for a Cargo Carrier and CURT Trailer Hitch, 2009 Toyota Prius
- Q&A: 4-Hole Spacing Measurements on Dexter 12 x 2 Inch Electric Trailer Brake Assemblies
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: Comparing Powered and Non-Powered Trailer Wiring Harnesses for a 2004 Nissan Xterra
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Choose the Right Trailer Hitch Class