How to Install Curt T-Connector Vehicle Wiring Harness# C55418 on 2002 Toyota Sienna
Published 04/24/2015
Question:
I rcvd your trailer hitch and wiring harness. Do you offer a video for installing the wiring harness?
asked by: GARY C
Expert Reply:
We sure do! I've linked you to the installation instructions as well as to an install video.
In a nutshell, you'll remove the rear threshold and pull back the trim panels on either side of the cargo area so you can access the back side of the taillight assemblies. You'll unplug the vehicle wiring harness from the taillight assembly, plugging the half of the harness with the YELLOW wire inline between the taillight assembly and the vehicle wiring harness on the driver's side. Route the half of the harness with the green wire across to the passenger side, using the area under the threshold to route the wires. This would also plug inline with the connection between the vehicle harness and the taillight assembly. You can see the entire procedure by viewing the video.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What is the Right Trailer Wiring Harness for a 2000 Toyota Sienna
- Q&A: Trailer Hitch Recommendation for a 2000 Toyota Sienna for Camper Towing
- Q&A: Towing Set Up for 2000 Toyota Sienna
- Q&A: Trailer Hitch and Wiring for 2025 Hyundai Santa Cruz
- Article: Redarc Tow-Pro Elite Full Review
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Replacement Axle and Leaf Springs for Pace American Enclosed Trailer
- Q&A: Can a 5.30-12 Size Tire be Replaced with a ST145/R12 Size Tire
- Article: My Trailer Hitch Doesn't Fit