Dimensions of the Weld-on Spring Latch Part Number SL58W
Published 04/21/2015
Question:
Could you advise the length of locking pin which extends from the front of mounting frame, when pin is in the captured release position roll pin in the retaining slots?
asked by: Beau S
0
Expert Reply:
I went to our warehouse to pull the Redline weld-on spring latch # SL58W to provide you the measurement you are requesting.
When the pin is captured, the roll pin will extend 3 millimeters or 0.11 inches. See the diagram I made for you.
Also, I included a short video review for you too.
expert reply by:
Chris B
0
click to enlarge
click to enlarge
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Recommendation for Dexter Axle 8-201 Hub Assembly on Older Horse Trailer
- Article: What Do I Need To Tow A Trailer?
- Q&A: Replacement Brakes, Hubs and Drums For Dexter 10K General Duty Prior To July 2009 With 9-44 Drums
- Q&A: Replacement Brake Assemblies for Dexter Trailer Hub 9-44
- Q&A: How to Install the Factory Ford Puck System on a 2007 Ford F-350
- Q&A: Trailer Brake Controller Connector Location for 2018 Toyota Tundra
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: What Size Hole is Needed for Installation of 2 inch Round Trailer Clearance Light MC53RB
- Q&A: What Size Hole is Needed to Mount Optronics 2-1/2 Inch Side Marker Light with Reflector and Grommet
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Hitch Installation Tips
- Article: Trailer Lighting Requirements
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision