Is there Any Trimming Involved when Installing the Curt Trailer Hitch on a 2004 VW Passt Wagon
Updated 04/16/2010 | Published 04/15/2010
Question:
Will there be any trimming of body parts, such as the fender or pieces attached to the fender, on a 2004 VW Passat wagon with this particular hitch?
asked by: Chris M
Expert Reply:
Yes, there could be some trimming when installing the Curt Trailer Hitch # C11054, on your 2004 V-dub Passat Wagon. According to the instructions linked below, you will most likely need to trim the passengers side fascia as needed to clear the bumper bracket. I spoke with my contact at Cequent, the manufacturer, and he said that when they do not specify how much will have to be trimmed, it is usually a small amount.
To do the trimming you would use a rotary tool, aviator sheers, or a razor knife. There is also a little drilling involved in the bottom of the trunk and up through the bumper. For the bumper, it is recommended that you use a high-quality carbide drill bit to get through the touch metal of the bumper.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Re-Securing Sensor On Factory Hitch for 2017 Mazda CX-9 with Curt Class III
- Q&A: What Bed Mat and Tailgate Liner Do You Recommend for My 2021 Ford Ranger?
- Q&A: Trunnion Bars for Use in Reese Dual Cam and Dual Cam High Performance Weight Distribution Systems
- Q&A: How Much of a Spindle Shaft Needs to Be Inside the Axle Beam
- Q&A: Does The Tonno Pro Lo-Roll Soft Tonneau Cover Work With Thule TracRac SR Ladder Rack?
- Q&A: Is Loctite Suggested When Installing Trailer Hitch Receiver
- Q&A: Will the Curt Hitch Fit a 2012 Chevy Camaro 2SS
- Shop: Roadmaster Reflex Steering Stabilizer with Mounting Brackets for Class A Motor Homes
- Shop: Trailer Wiring