Diameter of Hole Needed to Mount Bargmann 7-Way Super Sealed Connector # 50-87-004
Updated 04/01/2015 | Published 03/31/2015
Question:
Hello, What is the hole diameter required to mount this plug. Not the hole pattern just the diameter required to flush mount the plug.
asked by: Ryan
0
Expert Reply:
You will need a 2 inch hole in order to mount the Bargmann 7-Way Super Sealed Connector, # 50-87-004. I have attached a diagram which illustrates the exact measurements of the connector.
expert reply by:
Leah S
0
click to enlarge
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Mounting Hardware for UWS Truck Bed Chests
- Q&A: Hole Dimensions for Hopkins 7-Way and 4-Way # HM48470
- Shop: Trailer Wiring
- Shop: B&W Ball and Safety Chain Kit for Ram Underbed Gooseneck Trailer Hitch
- Search Results: gooseneck hitch
- Shop: Vehicle Tow Bar Wiring
- Shop: Gooseneck Hitch
- Q&A: My Surge Brakes Are Activating When I Back Up My Trailer - What Can I Do?
- Q&A: How to Properly Set Gain/Sensitivity of The Curt Echo Wireless Brake Controller # C51180
- Q&A: Recommended 6-Way to 6-Way Coiled Flat Tow Umbilical Cord
- Q&A: Can the Curt Echo Brake Controller C51180 Be Installed Perpendicular To the Direction Of Travel
- Q&A: How to Wire a 6 Pole Round Trailer End Plug
- Q&A: What is Normal Temperature Rating for Trailer Hubs