Is Fascia Cutting Required to Install Hitch 13251 on a 2006 Jeep Grand Cherokee
Updated 03/25/2010 | Published 03/24/2010 >
Question:
Does the rear bumper cover need to be cut out to install this hitch?
asked by: Russ M
Expert Reply:
Hitch # 13251 does not require any fascia cutting for installation, but you will need to remove your tow hooks, if your 2006 Jeep Grand Cherokee is equipped with them.
You will need to remove the plastic push fasteners so you can pull back your bumper cover, but these would be re-inserted after the hitch is installed.
I have included a link to the installation instructions, and an installation video for a similar vehicle showing how the push fasteners are removed and re-installed.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 5500 lbs WD GTW
- 2 Inch Hitch
- 550 lbs WD TW
- No Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What is Difference between etrailer and Curt Hitch for 2024 Toyota RAV4
- Q&A: How is Backspacing of a Trailer Wheel Determined
- Q&A: Replacement 17-1/2" Wheel Recommendation with 8 on 6-1/2" Bolt Pattern
- Q&A: Center Wheel Disk Thickness Taskmaster Solid Center Wheel w/ -0.19 Offset
- Q&A: What Ball Mounts Work with the Reese Sway-Control Bracket for 2" Ball Mounts RP26003
- Q&A: Is It Possible For Reese Sway-Control Bracket To Bend When Making Sharp Turns?
- Q&A: Will the Reese Sway-Control Bracket work with the Cushioned Ball Mount for 2" Hitches?
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams


