Recommended Wet Bolts With Screw-In Zerk Grease Fittings
Updated 01/30/2015 | Published 01/29/2015 >
Products Featured in This Question
Question:
I am in the process of rebuilding my trailer and would like to use wet bolts for the suspension. I read over and over here how the zirks in these bolts fail in one way or the other, Without a sealing ball to keep the dirt out and the grease in they seem like a waste of money. Add the fact that the zirks pull out very easily and you have a failed part. Is there another manufacturer of these types of bolts who uses a screw-in zirk? If not, would it be possible for the end-user to pop these zirks out and thread the bolts for a screw-in zirk?
asked by: Dave S
Expert Reply:
We offer 2 wet bolts that may work for you because they have screw-in Zerk fittings.
The first wet bolt I recommend is part # 34007-187-00. This is a step wet bolt designed to work with 1-3/4 inch double eye leaf springs. The overall length of this bolt is 3-7/16 inches and the usable length is 3 inches. This is a 9/16 inch diameter bolt. These are sold individually so you would need to enter the quantity you need when ordering.
The other wet bolt I recommend is part # 126A1. This bolt is used to secure the equalizer to the center hanger on a tandem or triple-axle suspension system. This includes the castle nut and cotter pin. This is a 3/4 inch diameter bolt that is 3-1/2 inches long. These are also sold individually.
Both of these wet bolts have the screw-in Zerk grease fitting.
If you decide on the wet bolts with the pressed in Zerk fittings, you can check out part # 126B2, and part # TRFA71063.
Product Page this Question was Asked From
Wet Equalizer Bolt with Locknut and Grease Zerk for Double-Eye Springs - 3" Long
- Trailer Suspension Parts
- Suspension Bolts
- Camper
- Car Hauler
- Utility Trailer
- 9/16 Inch Diameter
- 2-5/16 Inch Long
- Redline
more information >
Continue Researching
- Shop: Wet Equalizer Bolt with Locknut and Grease Zerk for Double-Eye Springs - 3" Long
- Video: Detailed Breakdown of the Dexter Single Axle Heavy Duty Suspension Kit
- Q&A: Shackle Suspension Kit for Single Axle Trailer With 3,500 lb Axle
- Q&A: What Are The Dimensions Of The Dexter Heavy Duty Suspension Upgrade Kit Part # K71-358-00
- Article: Trailer Wiring Diagrams
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Are There Shorter Pivot/Support Arms Available for the B&W Companion to Lower the Hitch More?
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Replacement Leaf Spring for a Dexter 072-079-01 Leaf Spring
- Q&A: How Is the 32-Inch Length Measured on the CE Smith Trailer Fender # CES63WR?
- Q&A: Will The Kodiak Disc Brake Kit K2HR10A11RERR Fit An AL-KO 10k #99 Spindle?
- Q&A: How Do I Measure Axle Spread for Upgrading The Trailer Equalizers?
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: Double-Eye Trailer Suspension System Review

