Curt Hitch Recommendation for a 1996 Chevy Tahoe
Published 01/28/2015
Question:
my tahoe does not have a back bumper it has a rollpan will hitch still fit i was told i needed a back bumper
asked by: Jim
Expert Reply:
The Curt Hitch part # C13029 has been confirmed as a fit for your 1996 Chevy Tahoe, there isn't any fit info available as to whether or not it will also fit vehicles with roll pan bumpers.
The best solution I can give you would be to check out the install instructions I attached to see how it installs as well as check out the install video that shows how a similar hitch installs on a similar vehicle. The hitch is designed to sit right underneath the bottom of the factory bumper. If your roll pan extends down below where the factory bumper sits it wouldn't fit most likely, or it would need to modified.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 600 lbs TW
- 6000 lbs GTW
- 10000 lbs WD GTW
- 2 Inch Hitch
- 1000 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Q&A: Looking For Budget Friendly Weigh Distribution Hitch To Pull 5K Dump Trailer
- Article: Trailer Lighting Requirements
- Q&A: Trailer Hitch for 2006 Dodge Sprinter That Fits Around Spare Tire
- Q&A: What Color Trailer Wires go to the Red, Black and White Taillight Wires
- Q&A: Hitch and Wiring Fits for 2004 Dodge Sprinter
- Q&A: Is there a Hitch for a 2025 Honda Accord Hybrid?
- Q&A: Recommended Hitch and Wiring for a 1994 GMC Suburban C1500
- Q&A: Replacement Spring Bar Cover For Reese Round Bar Weight Distribution System
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch