Installing Brake Controller And Wiring Adapter On 2014 Jeep Wrangler Trail Hawk

Updated 01/20/2015 | Published 01/19/2015

Products Featured in This Question

Draw-Tite Activator IV Trailer Brake Controller - Up to 4 Axles - Time Delayed

(357)

$103.31

Tekonsha Custom Wiring Adapter for Trailer Brake Controllers - Dual Plug In

(79)

$15.79

Question:

2014 Jeep Cherokee Trail Hawk

asked by: William O

Helpful Expert Reply:

For your 2014 Jeep Cherokee Trail Hawk, the brake controller installation is really quite simple.

You need to locate the connector under the dash on the left side of the steering column. You then plug the gray colored end of the harness, part # 3014-P into that connector. Route the harness to the location you want to install the brake controller, part # 5504. Next, you will install the brake controller in a location you can easily reach. After you have the controller secured you simply plug the connector on the back of the controller into the end of the harness.

The included instructions will tell you how to adjust the controller. This controller is for electric only brakes and is designed for 1 to 4 axles. This is a time-delayed brake controller that lets you adjust the amount of power you send to the brakes based on the load you are towing and the terrain.

expert reply by: Jeffrey L