Dimensions for Ultra-Fab Steel Jumbo Roller # UF48-979023
Published 01/08/2015
Question:
What are the overall dimensions of this roller, i.e. from bottom of roller to top of mounting plate and width of mounting plate? Also, do you know what the maximum weight rating is for this roller? I want to use it on a 38foot rear engine Newmar motorhome. Thanks,
asked by: Ron R
Helpful Expert Reply:
The overall height from the bottom of the roller to the top of the mounting plate of the Ultra-Fab Steel Jumbo Roller # UF48-979023 is 3 inches, the width of the mounting plate is 2-1/2 inches.
These don't have a weight rating because the way they are used would make it hard to give them a rating. My contact at Ultra-Fab said that because these rollers are not meant to sustain weight for extended periods of time, they do not have a weight capacity.
Product Page this Question was Asked From
Ultra-Fab Steel Jumbo Roller for Trailers and RVs - Weld On - 2-1/2" Wide x 3" Tall
- RV Skid Wheels
- Frame Mount
- Hitch Mount
- 2-1/2 Inch Diameter Roller
- Weld-On
- Ultra-Fab Products
more information >
Continue Researching
- Q&A: Looking for Hitch Mounted Skid Roller for 3 inch Hitch Tubing
- Q&A: Looking For Replacement For EB01-120 And EB01-125 Brake Assemblies
- Q&A: Can Brake Drum Be Added To etrailer e37YR 2K Axle With Idler Hubs?
- Q&A: Skid Wheel Kit with 4" Diameter Wheels
- Q&A: Dimensions of Replacement Ball Bearing for Kwikee SuperSlide and SuperSlide II
- Q&A: Do Ultra-Fab Steel Jumbo Roller for Trailers UF48-979023 Have Weight Capacity
- Q&A: Dimensions Of Ultra-Fab Steel Roller
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)
- Article: 4 Common Myths About RV Solar Power
- Article: Does Solar Panel Type Really Matter?
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: Spring Towing Readiness Checklist
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)