Do Ultra-Fab Steel Jumbo Roller for Trailers UF48-979023 Have Weight Capacity

Question

Question:

How much weight capacity for these wheels

asked by: Juan D

0

Expert Reply:

The Ultra Fab roller part # UF48-979023 do not have a weight capacity. My contact at Ultra-Fab said that because these rollers are not meant to sustain weight for extended periods of time, they do not have a weight capacity stated.

expert reply by: Jameson C

0

Answer 1

There are really only two standard trailer tire sizes for 15" wheels, 205/75-15 and 225/75-15 with the latter being the taller option (28.4" diameter x 8.9" wide vs. 27.3" diameter x 8.1" wide). I recommend the Karrier…

view full answer...

Answer 2

I might have a solution for you. However, the Ultra Fab 4 Inch Caster Wheels, #UF48-979011, will not be a viable option for your trailer. The best option will be to use the Ultra Fab Steel Jumbo Rollers, #UF48-979023. These roller have a 3 inch long…

view full answer...

Answer 3

The skid wheel part #UF48-979023 would work well for you as it's the largest size we have to fit your trailer. This shouldn't hurt your frame strength either. The more you have the better it will distribute the weight. So going with one on…

view full answer...

Answer 4

It would be a good time to replace both of your rollers with the part #UF48-979023 that you mentioned. There isn't a set grease schedule for these but if you greased them once a season, or even once at the beginning of the season and once at the…

view full answer...

Answer 5

The Ultra-Fab Steel Jumbo Roller #UF48-979023 you were looking at comes as a quantity of one, so if you're needing a pair you'll need to order two.

view full answer...

Answer 6

The Ultra-Fab Steel Jumbo Roller #UF48-979023 uses a special wet-bolt to grease the skid wheel as needed. This bolt is unfortunately not an item that we currently carry so you would need to reach out to the manufacturer for a replacement. That being…

view full answer...

Answer 7

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 8

The easiest skid wheel we carry to use is the Roadmaster Rollaway Trailer Hitch Protector #RM-050 which simply connects to a trailer hitch with a pin. That being said it doesn't look like your 32' Keystone Montana has a trailer hitch, based…

view full answer...

Answer 9

To determine the correct height and location to install the Ultra-Fab Steel Jumbo Roller for Trailers and RVs #UF48-979023 you'll want to take a piece of wood or something long enough and straight to wedge up next to your tire and then hold at an…

view full answer...

Answer 10

I do have an option for you. Due to the length of your 5th wheel and size of your bumper, we do not have a bolt-on option available. That being said, you can use the Ultra-Fab Steel Jumbo Roller for Trailers and RVs #UF48-979023 which is a weld-on…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Do Ultra-Fab Steel Jumbo Roller for Trailers UF48-979023 Have Weight Capacity

Product Page this Question was Asked From

Continue Researching