Could the Piano Hinge # H300 be Used as a Hinge for a Trailer Ramp

Question

Question:

will this work on my trailer door for a 12inch ramp full length to the ground?

asked by: Rick A

1

Helpful Expert Reply:

The # H300 is a 6 foot long piano hinge. It would work well for you to use as a hinge for a fold down trailer ramp. If needed, you could cut the hinge down shorter.

We have several customer reviews left for this product that mention how well it worked for doing exactly what you are looking to do.

expert reply by: Jameson C

1

Answer 1

The Replacement Furrion Monitor Power Cable #C-FOS07TAPK-006 powers the monitor. I believe you are looking for the 7-Way Vehicle Power Adapter #FR87PR that eliminates the PWM issue that causes the Furrion Vision S #FOS05TASF cameras not to get the…

view full answer...

Answer 2

I recommend replacing the 110v florescent light with a LED RV Utility Light #DG52529VP. This light assembly is only 3/4" tall so it will help prevent you from hitting your head on the lights. They use LED's which handle the vibration and…

view full answer...

Answer 3

The best option we have for you is the Continuous Stainless Steel Hinge part #SH300. This hinge is 6' long, 3" wide, and has 1" long knuckles. The overall length of the hinge will be an exact fit but the width will be about 1/4"…

view full answer...

Answer 4

The main factor in choosing the correct replacement piano hinge is pin diameter which then in turn, denotes capacity. The hinge width and material are also all worthwhile contributing factors. The Continuous Piano Hinge part #MA85VR for example uses…

view full answer...

Answer 5

Marlboro piano hinges like the 3" Wide Continuous Hinge #MA74ZR you're looking at do no have weight capacities. Marlboro mentions that it will be up to the installer to determine if the hinge will be strong enough.

view full answer...

Answer 6

Hey Paul! The Rubber Hollow Bulb Seal for RV and Trailer Door #CS92FR from Clean Seal doesn't have a recommended or required adhesion promoter. Just make sure the surface is clean and prepped. Any old adhesive should be removed and you can prep…

view full answer...

Answer 7

Yes, you can absolutely install the MaxxFan Dome on the sidewall of your trailer; in fact, it is designed to be installed either in the sidewall or the roof; the correct part number for the vent is the following: - MaxxFan Dome Plus Roof Vent w/ 12V…

view full answer...

Answer 8

Determining between piano hinges, #H300 3 Inch Wide Steel 6 Ft Long or #SH200 2 Inch Wide Stainless Steel Hinge 6 Ft Long, depends what features you find more important for your application. The #H300 hinge will be stronger in that it is an inch…

view full answer...

Answer 9

To replace your 12" brakes I recommend checking out the 7K TruRyde Electric Trailer Brake Kit #TRU96FR or the 5.2K - 7K Hydraulic Trailer Brake Kit #AKUBRK-7 depending on what kind of braking system you have. You'll also need the Mounting…

view full answer...

Answer 10

We may have a replacement hub for your Dayton Fayette 9254, but the only way to be sure is by determining which bearing combination and grease seal your spindle uses. You will need to remove one of the hubs and look for the bearing numbers stamped in…

view full answer...

Answer 11

Thanks for the picture! The closest seal we have to yours is the Rubber Hollow Bulb Seal for RV and Trailer Door item #CS63FR. This is a stick on seal that measures 15' long x 1/2" wide x 3/8" tall.

view full answer...

Answer 12

So it looks like the Lippert Slam Latch for RV Doors #LC54PJ will fit into a 3-3/4" x 3-3/4" cutout hole, and a 1/2" thick door. With your door being a half inch thicker, this slam latch is not going to work. Instead, I recommend going…

view full answer...

Could the Piano Hinge # H300 be Used as a Hinge for a Trailer Ramp

Product Page this Question was Asked From

Continue Researching