Free-backing, hydraulic trailer brake assembly won't engage when you reverse, even if your hydraulic actuator is activated. Mounting flanges have a 5-bolt pattern. Fits 16" and larger wheels. Corrostion-resistance is ideal for boat trailers.
Free-backing, hydraulic trailer brake assembly won't engage when you reverse, even if your hydraulic actuator is activated. Mounting flanges have a 5-bolt pattern. Fits 16" and larger wheels. Corrostion-resistance is ideal for boat trailers.
Power your adventures with the GoBlock Inverter Connector Cable! Effortless, plug-and-play connection to your 400W Redarc inverter keeps you charged up, off-grid, and ready for the wild. Built tough, so you can explore worry-free!
This replacement inner member slide easily fits into the existing housing of your Dexter XR84 or Legacy UFP surge brake actuator. For use with triple-axle trailers with hydraulic disc brakes.
Protect your brakes from dust and grime with this dust shield. Works for your 12-1/4" X 2-1/2" brakes for 7.2K axles. The 4-hole mounting pattern makes it easy to install. Painted finish provides a level of corosion resistance.
Multipurpose cable lets you wire a solar panel with Anderson connectors to a solar charge controller with hardwire inputs. Also can be used for adding extra cable length to solar panels, or connecting to chargers or battery management systems.
Side mounts work with corner mounts (RED79VR - sold separately) to attach single or multiple Redarc solar panels to an RV or boat. Attach mount to surface using a silicon adhesive or common fasteners.
This custom battery tray mounts to the floor of your RV or camper to keep your Alpha150 battery securely locked in place during travel. Quick and simple installation with countersunk fasteners.
The PowerDock secures your GoBlock, charges it fast, and simplifies setup. Lock your GoBlock in, hit the trail, and pop the quick-release handle to go portable. With solar priority and anti-theft features, it's ready for any adventure!
Multipurpose cable lets you wire a solar panel with MC4 connectors to a solar charge controller with hardwire inputs. Also can be used for adding extra cable length to solar panels or connecting to chargers or battery management systems.
Need to get your PowerDock wired up for your next adventure? This kit makes it easy with color-coded cables, tough hardware, and room to customize. It's built for rough trails, so you can get set up and get going in no time!
Wire loom and sensors allow you to monitor levels in your fresh-water tank with your RedVision Total Vehicle Management System. Reads tank state in 20% increments.
This replacement inner member slide easily fits into the existing housing of your Dexter A-84 Series or Legacy UFP surge brake actuator. For use with single or double-axle trailers with hydraulic disc brakes.
Keep your GoBlock safe on every adventure! The transit bag's rugged Oxford polyester material, rubber feet, and handy pockets make it the perfect travel buddy. Dust, dirt, or rough trails? No problem. Grab your gear and go!
Replaces the "D" washers, retainer nuts, and hex nuts needed to secure the brake hubs on your Dexter trailer axle manufactered after June of 2002. Includes 2 "D" washers, 2 retainer nuts, and 2 hex nuts.
Upgrade your boat trailer's braking power with this rust-resistant GalvX disc brake. Kit includes 1 pre-greased hub, inner (L68149) and outer (L44649) bearings, rotor, caliper, mounting brackets, and lug nuts.
Restore the performance of your Fortress oil cap with this complete service kit. Includes rubber plugs, oil fill plugs, and O-ring seals to prevent leaks, maintain pressure, and keep your hub looking squeaky clean.
Fuse kit contains 2 high-quality, 50-amp fuses with a protective holder. Works with Redarc TVMS Rogue (RED92RR) or Manager30 (RED88FR, RED93FR). Fuses protect your setup from potentially damaging overcurrent caused by short circuits or overloads.
Filter Results
