New Arrivals

Free-backing, hydraulic trailer brake assembly won't engage when you reverse, even if your hydraulic actuator is activated. Mounting flanges have a 5-bolt pattern. Fits 16" and larger wheels. Corrostion-resistance is ideal for boat trailers.

• Accessories and Parts
• Trailer Brakes
• Hydraulic Drum Brakes
• LH
• 12000 lbs
• Brake Assembly
• 12 x 2 Inch Drum
• Dexter

Replaces the "D" washers, retainer nuts, and hex nuts needed to secure the brake hubs on your Dexter trailer axle manufactered after June of 2002. Includes 2 "D" washers, 2 retainer nuts, and 2 hex nuts.

• Accessories and Parts
• Trailer Spindles
• Trailer Axles
• Trailer Suspension Parts
• Spindle Retainer Kit
• Dexter

Restore the performance of your Fortress oil cap with this complete service kit. Includes rubber plugs, oil fill plugs, and O-ring seals to prevent leaks, maintain pressure, and keep your hub looking squeaky clean.

• Accessories and Parts
• Trailer Bearings Races Seals Caps
• Service Kit
• Dexter

This replacement inner member slide easily fits into the existing housing of your Dexter A-84 Series or Legacy UFP surge brake actuator. For use with single or double-axle trailers with hydraulic disc brakes.

• Accessories and Parts
• Brake Actuator
• Disc Brakes
• Inner Member
• Dexter

Upgrade your boat trailer's braking power with this rust-resistant GalvX disc brake. Kit includes 1 pre-greased hub, inner (L68149) and outer (L44649) bearings, rotor, caliper, mounting brackets, and lug nuts.

• Accessories and Parts
• Trailer Brakes
• Disc Brakes
• LH
• RH
• 3500 lbs
• Brake Assembly
• Hub and Rotor Assembly
• Dexter

Replaces the shoe and roller for your passenger's-side Dexter 15,000-lb 12-1/4" x 5" air brake.

• Accessories and Parts
• Trailer Brakes
• Brake Shoes
• Dexter

Your Fortress bolt-on cap has been holding it together - now it's time to return the favor. This service kit gives your Fortress cap fresh gaskets, oil fill plugs, and hardware it needs to stay leak-free and pressure tight.

• Accessories and Parts
• Trailer Bearings Races Seals Caps
• Service Kit
• Dexter

This replacement inner member slide fits into the existing outer member housing of your Dexter or Tie Down surge brake actuator. Fits actuator models LP80, LP85, and LP8500.

• Accessories and Parts
• Brake Actuator
• Hydraulic Drum Brakes
• Disc Brakes
• Inner Member
• Dexter

Replace worn or leaking copper washers on your Dexter disc brake caliper. These 7/16" crush washers provide a tight, reliable seal between the banjo fittings and calipers to help prevent brake fluid leaks in your hydraulic braking system.

• Accessories and Parts
• Trailer Brakes
• Disc Brakes
• Caliper Parts
• Hardware
• Washers
• Dexter

Replaces the OneControl Advantage controller with Bluetooth for your Lippert Level Up RV leveling system. Fits all Lippert Level Up leveling systems. Includes flat mounting brackets and hardware.

• Accessories and Parts
• Camper Jacks
• Controllers
• Control Module
• Lippert

Restore push-button power to your Solera awning with this replacement arm kit featuring matching 69 inch Regal arms, flat-back mounts, top-routed wiring, and a black 12-volt rocker switch - just swap the arms and keep your current fabric and roller.

• Accessories and Parts
• RV Awnings
• Arms
• 69 Inch Long
• Pitch Arms
• Flat Awnings
• Black
• Lippert

A damaged harness can make your RV's leveling system unreliable. This 25' replacement restores electrical connections, helping your jacks work smoothly. Designed for Lippert Level-Up systems, it's a simple fix to get you back to camping.

• Accessories and Parts
• Camper Jacks
• Trailer Jack
• Wiring Harness
• Lippert

Advantage 4-point Ground Control LCD electronics kit.

• Accessories and Parts
• Camper Jacks
• Trailer Jack
• Controllers
• Control Panel
• Lippert

Replaces the electric steps, motor, and control unit for your Kwikee 47 Series RV step. Motor and control unit automatically extend and retract the steps when you open and close the door. Wiring pigtail hardwires to your RV's power.

• Accessories and Parts
• RV Steps
• Motors
• Control Module
• Steps
• Lippert

This kit includes the hardware for your Solera 2000 Series or Edge awning. The needed awning roller tubes and fabrics are sold separately. The 58" long arms offer sliding adjustable pitch. The wire is located at the bottom.

• Accessories and Parts
• RV Awnings
• Arms
• Pitch Arms
• Lippert

Replaces the cartridge valve for your Lippert Flow Max kitchen or bathroom faucet.

• Accessories and Parts
• RV Faucets
• Cartridge
• Lippert

Replaces the drive arm assembly for your Lippert Edge RV awning without LEDs. Includes both the drive head and the arm. Black color matches your existing awning.

• Accessories and Parts
• RV Awnings
• Arms
• Drive Arms
• Lippert

Replaces the mount for your Solera 3000 Series RV awning.

• Accessories and Parts
• RV Awnings
• Mounting Hardware
• Lippert

Electric ground supply and wiring harness connects to the controller, breaker, and battery of your Hall Effect leveling system.

• Accessories and Parts
• Camper Jacks
• Wiring Harness
• Lippert

A damaged harness can make your RV's leveling system unreliable. This 4-pin interface harness restores electrical connections, ensuring smooth jack operation. Designed for Lippert Level-Up systems, it's a easy fix to get you back to camping.

• Accessories and Parts
• Camper Jacks
• Trailer Jack
• Wiring Harness
• Lippert

Lost or bent your extension rods? This replacement set gets your white Solera slide-out awning working like new again so you can get back to smooth RV living.

• Accessories and Parts
• RV Awnings
• Extension Rod
• White
• Lippert

Replaces the control board for your Lippert OneControl electric Travel Trailer RV leveling system (672136).

• Accessories and Parts
• Camper Jacks
• Controllers
• Control Panel
• Lippert

Use this Grade 5 flange nut with Grade 5 bolts (sold separately) to mount your Lippert components on your RV. Secures your steel or aluminum, manual pull-out Tread Lite steps or Ground Control 3.0 front jacks. Zinc plated to resist corrosion.

• Accessories and Parts
• Camper Jacks
• Hardware
• Nuts
• Lippert

This is the most convenient way to add LEDs to your RV awning: the light is pre-installed in a plastic strip and mounts to the wall. It's designed to get max brightness with minimal power, reflecting off the RV wall to fill the patio with light.

• Accessories and Parts
• RV Awnings
• Lights
• 16 Feet Long
• Strip Light
• Black
• Lippert