This replacement inner member slide easily fits into the existing housing of your Dexter XR84 or Legacy UFP surge brake actuator. For use with single or tandem-axle trailers with hydraulic disc brakes.
Free-backing, hydraulic trailer brake assembly won't engage when you reverse, even if your hydraulic actuator is activated. Mounting flanges have a 5-bolt pattern. Fits 16" and larger wheels. Corrostion-resistance is ideal for boat trailers.
Replaces the "D" washers, retainer nuts, and hex nuts needed to secure the brake hubs on your Dexter trailer axle manufactered after June of 2002. Includes 2 "D" washers, 2 retainer nuts, and 2 hex nuts.
Restore the performance of your Fortress oil cap with this complete service kit. Includes rubber plugs, oil fill plugs, and O-ring seals to prevent leaks, maintain pressure, and keep your hub looking squeaky clean.
This replacement inner member slide easily fits into the existing housing of your Dexter A-84 Series or Legacy UFP surge brake actuator. For use with single or double-axle trailers with hydraulic disc brakes.
Upgrade your boat trailer's braking power with this rust-resistant GalvX disc brake. Kit includes 1 pre-greased hub, inner (L68149) and outer (L44649) bearings, rotor, caliper, mounting brackets, and lug nuts.
Your Fortress bolt-on cap has been holding it together - now it's time to return the favor. This service kit gives your Fortress cap fresh gaskets, oil fill plugs, and hardware it needs to stay leak-free and pressure tight.
This replacement inner member slide fits into the existing outer member housing of your Dexter or Tie Down surge brake actuator. Fits actuator models LP80, LP85, and LP8500.
Replace worn or leaking copper washers on your Dexter disc brake caliper. These 7/16" crush washers provide a tight, reliable seal between the banjo fittings and calipers to help prevent brake fluid leaks in your hydraulic braking system.
Replaces the OneControl Advantage controller with Bluetooth for your Lippert Level Up RV leveling system. Fits all Lippert Level Up leveling systems. Includes flat mounting brackets and hardware.
Restore push-button power to your Solera awning with this replacement arm kit featuring matching 69 inch Regal arms, flat-back mounts, top-routed wiring, and a black 12-volt rocker switch - just swap the arms and keep your current fabric and roller.
A damaged harness can make your RV's leveling system unreliable. This 25' replacement restores electrical connections, helping your jacks work smoothly. Designed for Lippert Level-Up systems, it's a simple fix to get you back to camping.
Replaces the electric steps, motor, and control unit for your Kwikee 47 Series RV step. Motor and control unit automatically extend and retract the steps when you open and close the door. Wiring pigtail hardwires to your RV's power.
This kit includes the hardware for your Solera 2000 Series or Edge awning. The needed awning roller tubes and fabrics are sold separately. The 58" long arms offer sliding adjustable pitch. The wire is located at the bottom.
Replaces the drive arm assembly for your Lippert Edge RV awning without LEDs. Includes both the drive head and the arm. Black color matches your existing awning.
A damaged harness can make your RV's leveling system unreliable. This 4-pin interface harness restores electrical connections, ensuring smooth jack operation. Designed for Lippert Level-Up systems, it's a easy fix to get you back to camping.
Lost or bent your extension rods? This replacement set gets your white Solera slide-out awning working like new again so you can get back to smooth RV living.