Fender Trim Specs:
Features:
These rear tube fneders protect your Jeep from flying debris and provide high clearance for Jeeps with large tires. Hardware included.
Installation Notes:
Drilling required for installation
Tech Tip:
Drilling is required to enlarge existing holes for hardware.
More Information >Fender Trim Specs:
Features:
These front tube fneders protect your Jeep from flying debris and provide high clearance for Jeeps with large tires. Hardware included.
Installation Notes:
No drilling required for installation
More Information >Videos
for Fender Trim
Help Articles
for Fender Trim
Expert Answers
for Fender Trim
Hi Richard! It sounds like you're needing to install the Load Resistor Kit for LED Turn Signals #DI34ZR on the turn signals you've installed on your toolbox. Since LEDs don't…
view full answer...Yes, there is! To install the Redarc Tow-Pro Elite Brake Controller item #RED63RR in your 2023 Subaru Ascent you will need the Plug-In Wiring Adapter for Electric Brake Controllers item #3062-P. The brake controller port will be underneath the dash…
view full answer...I recommend going with the 5,000lb Firestone Ride-Rite Air Helper Springs #F35FV on your 2023 Ford F-250 super duty. These have a capacity which is higher than what your F-250 is even capable of supporting on the rear axle. The 7,500lb Firestone…
view full answer...I do have an option for you but roof rails won't work very well on a teardrop trailer, even if you were able to get the rails to conform, it's likely the accessories would bind due to the steep angles. Instead,…
view full answer...The AL-KO trailer hub part number 8700 that you have is a 3,500 lb trailer hub/drum with a 5 on 4-1/2 inch bolt pattern. Based on that the #AKHD-545-35-EZ-K is the correct fit and would work great.
view full answer...I must recommend that you replace the hub/drum as well when changing the size of your braking assemblies because the surface area on the old drums may not line up with the new braking assemblies which is why I recommend replacing both at the same…
view full answer...The E-Track has slots that have a length of 2.45-inches and a width of .58 inches. See attached diagram.
view full answer...When you have the minimum air pressure in the air bag kits like the Firestone kits that fit your 2020 Ford F-350 it would not affect the ride quality at all. As you add pressure you may notice it get bouncier. The ride quality is not significantly…
view full answer...For Firestone air bags on your 2022 Ford F-350 Super Duty, the weight ratings are listing its max capacity. The Ride-Rite springs will not increase your truck's weight-carrying capacity but designed to increase safety and reduce…
view full answer...The Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F95FV are 7,500lb capacity air bags for your 2020 Ford F-250 Tremor. Remember that these do not increase your payload or trailering capacities but rather provide additional support…
view full answer...Out of the two Firestone kits that we offer I recommend The The Firestone Ride-Rite Air Helper Springs #F35FV because you're only towing a 10,000 pound trailer and your pin weight will be under 5,000 pounds which will provide you…
view full answer...Though the Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F2709 will offer you more support when fully loaded, they will also affect your ride a lot more when not loaded. Even at the lowest setting (5 psi). I really only recommend…
view full answer...