2007 Jeep Wrangler Unlimited Fender Flares

Yes, you can! Both the Curt item #C99FR and etrailer item #e75ZR hitches have been confirmed to fit the 2022 Toyota Highlander XSE's with dual exhaust. These hitches are essentially identical with the exception of the finish. I recommend going…

The correct replacements we offer for the Glo Brite Marker Lights 118A and 117R is the Trailer Clearance or Side Marker Light part #MC44AB for amber and part #MC44RB for red.

I do have almost everything you will need to repair your Roadmaster Sterling Tow Bar SN #005384 but after speaking with my representative at Roadmaster, they strongly advised me that you should replace the tow bar due to the sheer age of the unit and…

We have found that the Replacement Motor #LG-142178 that you referenced is indeed compatible as a replacement for your existing Atwood 75722 motor.The only thing I recommend doing is verifying that the legs on your motor aren't flush with the…

Yes, the Kenda Karrier S-Trail ST145/R12 Radial Trailer Tire #AM10140 referenced in your question will fit the same 12 inch wheel with a 4 inch width that your existing 4.80-12 size tires are mounted to. Just note that the ST145/R12 tire will be…

The lights you referenced in the photo for the Aries Front Fender Flares #AA1500201 wouldn't be factory lights. There is a similar product available for your 2012 Jeep Wrangler Unlimited that work with the aforementioned Fender Flares. The Aries…

We have what you need. I will list them below for you. The Blue Ox Aftermarket Off-Road Bumper Adapter - 7/8" Pin #BX88357 for your 1 inch D-rings. The etrailer SD Non-Binding Tow Bar for Blue Ox Base Plates - RV Mount - 2" Hitch - 6,000…

For a bumper mounted spare carrier that has capacity for an 80 lb setup we have the part #BR56VR from Brophy that fits a 4 inch bumper like you have and would work well.

Demco has a base plate kit that fits your 2016 Jeep Rubicon Hard Rock with the part #DM56GV which is correct fit with the Demco Commander II part #DM9511012 you have as well.

If 380 pounds is the tongue weight of your trailer, then you are correct. You add the tongue weight of the trailer to bike rack and bikes, and that total is your total tongue weight. Make sure you are within the tongue weight capacities of both your…

The center of the hitch pin hole for the Draw-Tite Max-Frame Trailer Hitch Receiver #DT37GR is 6" further out than the center of the hitch pin hole for the Curt Trailer Hitch Receiver #C76WR. Since the hitch pin hole determines where your…

Yes, it does. The arm on the Kuat Pivot 2 Swing Away Hitch Extender item #PVD20B locks at 90 degrees and opens up to 120 degrees. I have attached a photo below that shows how this function works.