2023 Jeep Gladiator Jeep Doors

On the Jeep Wrangler and Jeep Truck models the steering wheel does not actually lock with the ignition in the off position, it just has a loss of power steering-which is likely what you're experiencing. Jeep removed the steering wheel lock from…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The Replacement 2 inch Hitch Adapter, part #853-7489, you asked about is an adapter, that Thule says will fit TH9028, TH9029, TH9030, TH9031 and TH934XTR bike carriers. They have the threaded hole in the shank that aligns with the hole on the…

You can use an isolating diode kit like #48955 to prevent tail light back-feeding in your flat towing set-up. Each stop and turn circuit (4 in total) will need a diode to allow signals to travel in only one direction, without back-feeding to the RV.

The Bestop Element Upper Doors, part #B5179515, that you referenced does fit a 1993 Jeep Wrangler, but it does not fit the 2009. The proper part number for the 2009 is #B5180535. This is for the upper door. If you need the full door, we have that…

For your 2022 Jeep Wrangler, the twist locks (the base plate tabs) will indeed connect to the end of the arms on the etrailer SD Non-Binding Tow Bar #e34ZR. You'll connect that directly to the Invisible Base Plate Kit #e98948. It's somewhat…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I found the online version of the install instructions for the Exact Center stabilizers like the #RM47MR. What's fun is that just when you think you have found the correct step to address your problem it tells you to continue to the next step.…

In regards to the Roadmaster Exact Center Steering Stabilizer part #RM47MR, the stabilizer installs on the front of the steering arm pointed down. I have attached a photo of this below. If this wasn't what you were looking for, please just let me…

This part is not specified for a 2001 Tacoma, so it is possible that the original owner may have installed it by other than the approved method intended by the manufacturer. The Westin Sportsman Grille Guard, part #40-1605, is specified to fit all…

You will have to verify that the Westin Grille Guard is one that came off of a 2001 Toyota Tacoma and would be part #40-0905. Every grille guard is made differently to match the vehicle and the hardware kit. You can't just take the hardware of a…