Keep your slideout protected with a Clean Seal bulb seal that fits over the flange and cushions the room. Match the side profile and dimensions to your original seal for the right fit, paying attention to the flange receiver and bulb size.
Yes, it can match original styles when the profile and dimensions line up. Pull a sample of your old seal and compare the bulb diameter and flange receptor before ordering. Aging seals can lose grip, so ensure the new press-on fit is tight and the bulb placement contacts the mating surface.
These are intended for RV slide outs, but they may work if the profile and dimensions match your application. Since OEM vehicle specs aren't confirmed, compare the side profile and measurements like 1-5/16" wide x 1" tall to your original. Only proceed if the fit and bulb placement look identical.
Match the side profile and dimensions to your old seal. Compare overall width and height, like 1-5/16" wide x 1" tall, to what you remove. Check the flange receptor width—1/2" is common—and the bulb diameter you need, such as 1/2" or 3/4". If the bulb placement is offset on your original, verify the new seal's bulb location will make proper contact.
Options include 15', 25', and 50' lengths. Measure the run you need—some installs only replace the center section if the ends are intact. Cut to fit as needed, and verify the bulb size and flange fit stay consistent along the entire length.
Yes, these are designed to press on over a flange. Confirm your slide has a flange and that the receptor matches, often around 1/2". Compare the bulb and overall size—examples include a 7/8" wide bulb or just under 1" tall overall—to ensure a snug fit and good sealing.
Filters
