# 1
Swagman Upright Bike Rack for 1 Bike - Roof Rack Crossbars - Frame Mount
Planning on bringing bikes while camping. I mounted 2 of the Swagman bike racks to my new Sportrack on my pop-up camper. The bikes fit perfectly. The racks seem sturdy enough. Not heavy duty, but for my needs they should be fine. Assembly was relatively fast and easy.
We have used the Swagman Roof Rack a number of times when we have needed the additional bike carrying capacity. It took a couple attempts to get the initial spacing of the bike rack properly balanced on the van’s roof rack as recommended by the instructions. But it was easy to do and once set was very easy and quick to put on and take off. The rack works great, the bike is easy to put into place and secure. The bike and rack are very stable and quiet and haven’t required any mid-trip adjustments. We always put the cheapest bike on the roof (lol) but do use a bit of duct tape to protect the finish just Incase. We are very satisfied with the rack and consider it quite a deal for the money.
# 2
Swagman Titan Bike Rack for 2 Bikes - 1-1/4" and 2" Hitches - Tilting
One of the few racks that will clear my Jeep's large rear mounted spare tire without using an extender. The other is the Allen which doesn't have the nice features the Swagman Titan has. Tips enough to allow partial opening of Jeep rear door, but enough to open the soft top rear window. The vertical portion of rack tips slightly toward vehicle (at least it does on mine). Would be better if the horizontal "S" shaped piece could be turned around to dip down, moving it further from the spare tire, but there are only holes drilled to mount it as shown. Can't attest to the durability yet, but it doesn't wobble even a tiny bit. Have to compliment everyone I spoke with at etrailer. very nice and extremely helpful.
eTrailer.com had my new Swagman Titan bike rack delivered super fast. I received the right amout of email communication informing me of the status of my order, plus I could track my delivery directly from the eTrailer website. Awesome! As for the hitch, I am so happy with it. I was tired of taking the front wheel off my bike and cramming it into the back of my small Corolla, it never really fit right, was always a struggle, and then I had no room for anything else in my car. Now, I just hang my bike onto the rack and strap it in, takes less than 60 seconds and I have all the extra room in my car and don't have to fold down the back seats. The other feature I really like is that this bike rack has an integrated locking cable, once your bike is on the rack, you attach the locking cable so now your bike is locked onto the rack. Someone can't take your bike off the rack and walk away with it when you aren't looking. I also got the Swagman bike rack locking pin, that attaches the bike rack to the car hitch. I've used the bike rack twice so far and it makes my life so much easier. Solidly built bike rack that is well worth it. Thank you eTrailer, you rock!
# 3
Curt 2 Bike Platform Rack - 1-1/4" and 2" Hitches - Frame Mount - Tilting
I installed this rack onto a Curt trailer hitch which is mounted onto a 2017 Honda Fit. I have been using it intermittently for several months, probably about 5 times with one bike and twice with two bikes. I give some pros and cons below and then elaborate. Pros: easy to assemble, easy to mount and dismount bikes, easy to lock and unlock, how to put the rack into different positions is intuitive Cons: inconvenient to put the rack into different positions, inconvenient to mount the rack onto the hitch, rack protrudes about 15 inches from bumper when in flipped up position (seems very vulnerable to someone backing into it in a parking lot, very inelegant looking I say the repositioning is intuitive because there is really only one way you could possibly place the pins for each position. But removing and replacing two pins is much less convenient than turning a knob or a lever, like some racks do. Also many racks fold and flip in such a way as to look very unobtrusive when in non-use mode. This one looks like kind of a monstrosity. That does not really bother me but it might bother some owners. The part that does bother me is how far it protrudes from the car. I back into parking spaces whenever possible to avoid someone bumping into the rack and damaging it (which happened to a friend). My number one suggestion for Curt is related to mounting the rack onto the hitch. Make it easier to tell when the holes are lined up so that the bolt/pin will fit and thread. As it is now, if you insert the rack as far as it can go it is way too far in. Ideally, it would be exactly lined up. Failing that, maybe some kind of click or other feedback to know at least that you are in the neighborhood. It would also be great to have an attaching device that is easier to fasten and unfasten than is the bolt/pin. Tip for mounting the rack onto the hitch: I assumed that it would be awkward to hold, what is it 46 pounds?, while trying to line up the rack probe with the receiver. If you have a garage with exposed collar ties, my solution could work well for you. I looped a cargo strap over a collar tie. Then I hooked both hooks of a bungie onto that loop. The idea is that you hook one of the bike frame holders of the rack onto the bungie, suspending the rack a few inches off the garage floor. This takes most of the weight of the rack so that you can just pull up or down and forward until you line up with the receiver. Tip for mounting bikes. Don't put the little screw into the post that prevents you from completely removing the bike frame holders. Remove both holders. Position the first bike, slide the holder into place, position the second bike, slide the holder into place. I found this makes it much easier, because you avoid parts of the bike hitting the holder as you are trying to get the wheels into place. The trick is that if you are mounting only one bike, don't forget to put the second holder back on - or maybe just stick it inside the car right away.
I had a 1 1/4" hitch installed on my 2016 toyota camry (the only size offered on the camry). I was very pleased with the ride. I expected to hear alot of noise like experienced when towing a trailer, but I heard almost nothing accept when going over speed bumps. I had to extend the tire supports to their widest position because having mountain bikes with a step through angled bar, they were more secure the closer i could get the upper and lower support arms to the seat post. The bikes were mounted in opposite directions and only stuck out maybe 6 inches or so. One locking barrel on the lower support arm was malfunctioning and gave me trouble but i called etrailer and they sent a replacement as soon as they were in stock. It comes with a anti rattle hitch pin but I highly recommend purchasing an anti rattle hitch pin with a lock on the end instead of just a clip for more security when unattended. After a few times mounting the bikes and figuring out the best way they should be positioned (pedals positions, direction of bike, and that my wife's smaller bike fit better going on first with my larger bike on the outside) I can mount the rack and bikes and be ready to go in just 5 minutes. (70 pounds on a torque wrench recommended for the hitch pin) I am overall pleased with my purchase i would recommend this product.
# 4
Yakima OnRamp Bike Rack for 2 Electric Bikes - 2" Hitches - Frame Mount
This is a great product and works beautifully! The only issue was some sloppily made plastic turn knobs that were cross threaded on arrival. However, Yakima immediately shipped out replacements. It carries two large E bikes easily. They fasten solidly and are easy to load and unload!
etrailer: prompt delivery, fair price! Rack: It does fit my (2) Gazelle T10 eBikes. 1) I found I had to adjust every setting to get bikes to fit. Until you learn there are many adjustments, it does not seem like the center/vertical clamps will reach both seat posts. 2) The ramp is barely usable; my wheels are max it will fit and you must have at least 12ft of clearance on each side of car to get bike lined up with ramp. 3) My bikes have a "walk" feature, this is not usable as its too awkward to hold the walk button down and move around the rack. I found its easier to abandon the ramp and load front then rear wheel. I will rig up a wheel stop, on ends of each wheel holder so bike will not roll off while I strap it in. 4) Rack did NOT come with a lock for hitch pin; this is very disappointing as they say in manual this is an optional item. Every rack I have seen at least has a clip that would otherwise hold the hitch pin in if somehow the bolt loosened up. 5) The rack weight is the lightest I have found. 6) You must load the first bike (closest to car) from car passenger side. This will avoid you bike pedals hitting the vertical bar. That means you must load the 2nd bike manually as there is no way to get the pedals past the vertical bar. I will get used to this, I hope. 7) The rack is a few inches above the receiver (part that goes into hitch) so if you have a low hitch this might be an issue with ground clearance. With both bikes mounted up, it seems very stable and hopefully will be secure in travel.
# 5
Kuat Transfer V2 Bike Rack for 2 Bikes - 2" Hitches - Wheel Mount
We love this bike rack. We bought a couple ebikes and needed something we could use behind our travel trailer when camping and the truck when we just want to drive to some trails. When we were looki g, many can't be used behind travel trailers. We absolutely love the way its built - its sturdy, high quality, pretty easy to put together - good instructions. Love the tilting feature - use one foot - very easy. Love that it comes with the cable lock for the bikes, It is very adjustable for a wide range of bikes. We have step throughs. We did buy a hitch lock for extra security. We would recommend this rack to anyone.
This Kuat rack will work great for me. I previously has the same rack but with the 1 and 1/4" hitch. That worked fine for our 2 bikes, but I upgraded to a heavier bike and needed the actual 2" hitch. Things I like better about this newer rack: 1. While cable locks aren't the most secure devices, they are better than nothing and this rack includes an integrated one. 2. It seems the hooks that go over the tire have a softer feel that will hopefully not make the bike front fork over time. 3. Assembly was easy. You'll never find anything requiring assembly that has clearer instructions! Also, it's great that Kuat includes all the necessary tools to complete the installation; no digging through my various tool boxes for the correct tools. In addition, the packing of the rack by Kuat was fantastic with everything protected and secure. Things that time will tell: 1. The finish on this is a flat power coat; my previous was grey with a sealed, smooth surface that was easy to clean. I'm not sure in the long run how easily this finish will be to clean. 2. The hole in the arm for the lock is open when the cable lock is not installed. This could certainly allow for water and dirt to enter the interior of the arm. Some sort of cover or plug for this hole would be a nice improvement. And, of course, the information on etrailer was great. Ordering was simple, delivery as expected. Another great job by etrailer.
What our customers are saying:
"Just to let you know I was very satisfied with my orders for a hitch, wiring harness, bike rack and extension. I have a 1995 Dodge Ram van and some of the parts are hard to get elsewhere. I received all my orders proptly and will recommend you to others. The pricing can't be beat. Thank you. Sincerely, Frank"