# 1
Swagman Upright Bike Rack for 1 Bike - Roof Rack Crossbars - Frame Mount
Planning on bringing bikes while camping. I mounted 2 of the Swagman bike racks to my new Sportrack on my pop-up camper. The bikes fit perfectly. The racks seem sturdy enough. Not heavy duty, but for my needs they should be fine. Assembly was relatively fast and easy.
We have used the Swagman Roof Rack a number of times when we have needed the additional bike carrying capacity. It took a couple attempts to get the initial spacing of the bike rack properly balanced on the van’s roof rack as recommended by the instructions. But it was easy to do and once set was very easy and quick to put on and take off. The rack works great, the bike is easy to put into place and secure. The bike and rack are very stable and quiet and haven’t required any mid-trip adjustments. We always put the cheapest bike on the roof (lol) but do use a bit of duct tape to protect the finish just Incase. We are very satisfied with the rack and consider it quite a deal for the money.
# 2
RockyMounts BrassKnuckles Roof Bike Rack for Fat Bikes - Wheel Mount - Aluminum - Black
The people at etrailer are excellent in communicating and following up. The Rocky Mount BrassKnuckles Roof Rack for Fat Bikes is well designed and came with comprehensive instructions. It fit my Thule aero blade racks wonderfully. My Motobecane Sturgis now sits proudly on my Volvo wagon. I have driven up to 60 MPH with my bike on the roof with no drama what so ever.
Excellent service from etrailer. Had to slightly modify rack arm to accommodate 27.5 x 4.5 w/ 150mm fork and studded tire, but I sort of expected that. The bike rack is sturdy and strong, I expect it to meet my needs. Thank you Rocky Mnt and etrailer!
# 3
Kuat Trio Roof Bike Rack - Fork Mount - Clamp On - Aluminum - Black and Polished Chrome
Installed all products after having watched videos and read through pdf instructions. The Yakima JetStream roof rack system is outstanding (with one exception) - instructions and videos facilitated the installation. The Yakima system is the only one I could find for my car (Mercedes E450 Coupe), as the car's panorama roof glass extends to the edges near the fixed mounts. The Yakima system is quiet, thanks to the ability to modify the crossbar pitch angles, and has a high-quality appearance that complements my car. And it is rock solid. The Kuat Trio bike tray is an outstanding low-cost, simple solution - well-designed and well-executed and installs to the Yakima JetStream bars flawlessly. I would recommend that Kuat include a 12mm x 100mm thru-axle in the Trio kit, as I had to purchase that part separately. Only disappointment is in the Yakima Landing Pad Covers that ship with the Landing Pad 22 (LP 22) kit. The covers do not snap tightly into place, and appear as if they were designed for a different Landing Pad. In summary, my Yakima/Kuat bicycle roof rack system exceeds expectations (except for the LP 22 Covers), operates flawlessly, looks great, and stores easily. It has given me high confidence in Yakima, in Kuat and in etrailer.com. Well done.
Great rack easy to install, light weight and well made.
# 4
Malone Pilot Roof Mounted Bike Rack - Wheel Mount
These were perfect to mount on my motorcycle tailer. The raised front wheel allowed me to fit it over a cross brace on the motorcycle wheel chock.
The Malone Roof bike rack I bought at Etrailer is perfect. It is simple to mount on the roof and simple to mount a bike on it. At one point I use it to drive my bike all the way from Ottawa Canada to Richmond Virginia, some 1,100 KM. The bike is so solid attached with Malone, there is no single movement of it. I strongly recommend to other to buy it.
# 5
Rhino-Rack Road Warrior Rooftop Bike Carrier - Fork Mount
This bike carrier has a clean design and it assembled and attached to the roof rack easily. A locking front cover prevents it from being detached from the roof rack and the tray has a cut out in the front for a disc brake if my next bike has one. Once everything is snug, the bike feels solid and there's no slop.
I'm not too sure how to rate this but I'm not happy with it. Everything that happened is no fault of etrailer. I've made many purchases from etrailer, they're a great distributor. The bike rack appears to be great. The problem seems to be that they changed the design. To start, UPS damaged the box in shipping and then tried to tape the package they sent me. After walking through the parts in the box with an etrailer rep on the phone, it seemed that no parts were missing. So I proceeded to connect everything up based on the instructions. As I put it together I noticed the mounting bracket in the rear doesn't have anything to remove the slop. The rear is literally resting on a slider, which means that it would rattle when driving around. Just for kicks I took it for a drive with my bike on top. It rattled like crazy! So I looked at the installation videos on etrailer and then youtube. Every one of them showed an extra rear mounting bracket with knobs to tighten. These were not listed in the install manual so I suspect Rhino thought they could cut cost by eliminating them. I contacted etrailer to see if they had any. They didn't. So I returned it. Sadly, I still had to pay a $25 restocking fee. I'm not sure why etrailer charged me. It's not like I bought the wrong thing and didn't want it. It's actually a really nice bike carrier. Just a flaw in the design that etrailer should catch when they test it out in their videos. If anything, I've helped them out with this. Hopefully etrailer will test out what I sent them, then reach out to Rhino about this new design flaw. Again, I like etrailer as a service but I wish they had caught this before selling to me (and others). I strongly suggest that you don't buy this until the bracket issue gets resolved. Also, take a look at the last pic of the Inno XA391 on the etrailer site. They resolve the rear bracket rattle by putting in a thumb screw.
# 6
Inno Tire Hold II Roof Bike Rack - Wheel Mount - Clamp On - Aluminum
So close! This rack is great, with a few caveats... First, it's almost too small for an XL (21" frame, 29" tires) mountain bike. I had to completely remove the adjustable wheel holder thingy on the rear arm (brace? lever? support?) to be able to properly fit my bike. Not a deal breaker, but not really working as intended, I think. Second, the front mounting bracket is... middling. It doesn't have a lever like the rear, and so tightness is purely dependent on how hard you can twist the little knob. Also, there's only one in the front, unlike the double setup in the rear. The brackets, themselves, aren't designed particularly well. I'm not sure what crossbars they were using as a baseline, but the angles just don't make sense. (at least to me...what do I know) What I do know, is that they don't grip the factory Outback crossbars very well, and I found myself constantly adjusting and tightening them to where I wouldn't get any sliding left to right on the crossbar. (I did finally get it to where I was satisfied, but it took some doing, and I imagine it would be like that every time if you wanted to take the rack off occasionally.) TL,DR: Does the rack do what I need it to do? Yes. Is the fitment a bit frustrating? Kinda. Are there other similar options out there? Not many, and none that I could find at this price point. Would I recommend, or buy again? Yes and Yes.
The bike rack worked well until the ratcheting teeth on the track became worn. Now I can't tighten the tire hold levers. I contacted customer service in March, and they said they would contact me when the replacement part came in. It's now November, and I'm still without a working bike rack. Definitely inhibited my mountain biking this summer, which was a huge bummer.
# 7
Yakima FrontLoader Wheel Mount Bike Carrier - Roof Mount
Overall I am happy with these bike carriers. They mount to the racks over the bed of my Tundra TRD Pro. Installation is simple. I think they could be just a bit sturdier because there is just a bit of wobbling when driving on bumpy roads but I'm not too worried about them coming dislodged. Take note that although they come with a cable lock to attach the bike to the carrier, the key is sold separately.
Very good product. It holds the bike securely on the roof without contacting the frame. It is easy to adjust from my road bike to my 29er mountain bike. Our drives are all relatively short, so I like that I do not need to remove the front wheel to lock in the bike. It's also nice that the SKS locking system allows me to use the same key for this rack that I use for my Yakima roof box and hitch rack. This is my first roof rack and I chose this route for a couple reasons. Some of the roads we travel to get to our trail heads are a bit rough and with a roof rack I don't have to worry about bottoming out a hitch rack hanging off the back of the vehicle. Also, it takes up less room in the garage. Our vehicle is a 2000 Jeep Grand Cherokee with an additional 4 inches of ground clearance. That makes it a bit of a reach for my 5'4" wife, so we take our two-step along to help her. This is my third time purchasing from etrailer, and each experience has been very good. They are a very customer service oriented company. I really appreciate all the additional information they provide on their products, especially all the videos they produce to aid in reviews, assembly, and use.
What our customers are saying:
"Hitch and Bike Rack were received very quickly, and were installed very easily."