Most Popular Hitch Bike Racks for 1991 Toyota Camry

I had a 1 1/4" hitch installed on my 2016 toyota camry (the only size offered on the camry). I was very pleased with the ride. I expected to hear alot of noise like experienced when towing a trailer, but I heard almost nothing accept when going over speed bumps. I had to extend the tire supports to their widest position because having mountain bikes with a step through angled bar, they were more secure the closer i could get the upper and lower support arms to the seat post. The bikes were mounted in opposite directions and only stuck out maybe 6 inches or so. One locking barrel on the lower support arm was malfunctioning and gave me trouble but i called etrailer and they sent a replacement as soon as they were in stock. It comes with a anti rattle hitch pin but I highly recommend purchasing an anti rattle hitch pin with a lock on the end instead of just a clip for more security when unattended. After a few times mounting the bikes and figuring out the best way they should be positioned (pedals positions, direction of bike, and that my wife's smaller bike fit better going on first with my larger bike on the outside) I can mount the rack and bikes and be ready to go in just 5 minutes. (70 pounds on a torque wrench recommended for the hitch pin) I am overall pleased with my purchase i would recommend this product.

Not perfect, but still the pick of the litter among affordable platform racks. Pros: sturdy, easy to assemble and use, two storage modes, mostly thick steel with minimal plastic, good depth (works well with my '05 Buick Lacrosse, with 1-1/4" hitch recessed about 6" behind bumper face), built in keyed locks. Quite solid Cons: barely fits tall bike, sloppy fabrication, cheap hardware; should reverse direction of short and long locking arms so taller, heavier bike goes inboard, anti-rattle hitch pin does not have a lock, so you have to buy one for $XX more. My story: assembly failed at the first step because the 1/2-20 shank bolt was mis-threaded such that it would not accept the nut. I was able to make it work by running a rethreading die over the bolt, removing a fair amount of metal. The good folks at etrailer sent me a replacement bolt, but I had to invest $3 in a new Nyloc nut. The black finish on the hardware (nuts, bolts, pins) is so thin it might as well have been applied with a Sharpie. The rack itself is nicely powder-coated. The bends and hole punching in the metal are sloppy. The rack lists to starboard, and the wheel support arms/hoops droop on the right side. It's just a cosmetic issue, but Curt should be embarrassed. I have a very tall bike (27" frame),and it barely fits. That said, it does fit, at the highest stop. If the mast were a few inches taller, it would be great. As it is, I have to finagle and slightly force the bike into place. I will probably remove the stop screw for the locking arm and just remove it entirely to load the bike. Finally, when you unpin the mast to move it into operational position from storage position, it will fall hard onto the trunk deck if you don't hold it. There needs to be a stop so the mast cannot rotate past vertical and damage the car. Overall, good solid rack, but not all it should be in design or execution.

Click to Enlarge

Click to Enlarge

The Swagman Chinook 2 bike rack is exactly what I was looking for. I assembled it from the directions and test fit my bike. I know I am going to be very happy with this bike rack.

In general, it is pretty good. a solid product. Only complaint I have is that the height of two hooks to hold bikes are very different, it would be hard to make them hook on two bikes with similar height. If you encounter this situation, what I do is to hook one bike and use rope or strap on another one.

Stable and well built bike rack. Got this rack and the Draw-tite hitch for a 2015 Camry XSE. I needed the s bend in the shank to clear my driveway apron. The back bottom of hitch is normally 9.5 inches off the ground, 8 inches with the hitch and 4 bikes (about 140 lbs). With 3 people in the car the clearance on my apron is less then 2 inches and it doesn't hit when all 4 are aboard. With the arms folded you can open and close the trunk, but when arms are up the trunk is blocked. This is the reason I knock it down one star. The cheapest thule looks like it is the reverse blocking with arms down, I wish the swagman was that way since it is way easier to tilt the rack with out the bikes. It is hard to get the some bikes over the large triangular cradles, but was able to do it for even my daughters small bike (one side is only on top of the cradle). The main problem with the cradles is that the attachment points for the straps are very flexible, which makes it hard to attach the straps, you end up having to bend the cradle which is hard when bikes are in the way. There is little movement side to side and up and down. The hitch is a tighter fit on the sides then top and bottom to hitch (even with bolt tightened down hard). Overall a very good rack. Customer service was excellent at answering my questions when I was placing the order. Thanks

Everything worked out fine!

The Swagman XTC-2 two bike rack works well with the model 36540 Draw-Tite Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4" on my 2017 Toyota Camry LE. The XTC-2 appears to be a really nice rack although I only have one outing under my belt. The rack is a good combination of sturdiness without getting ridiculously beefy and heavy. My only gripe is it's not clear if the rack can be easily locked to the hitch. Great package delivery from Etrailer.com. The online videos and reviews were very helpful in making my selection.

Product works great, dragged our two bikes all the way from Minnesota to Florida (and back) with absolutely no issues. We did use the "CURT 18050 Bike Rack Support Strap" to help stop the bike rack from bouncing around too much. It works quite well.

Bought for my Toyota Camry, very happy. It also came with and adapter so it could be used on another sized trailer hitch. It'll now go on our other vehicle as well which I'm very pleased about. My only wish is that when on insert to the hitch you have to use a screw to secure it as appossed to a pin clip. Once rack is attached to your vehicle you must use a tool to detach it. I'd like to easily be able to take it on and off so I don't have to constantly be driving around with the rack on my car. Other than that it's sturdy, easy to set up and mount bikes to.

The Thule is a secure system for 4 bikes. Once I spaced the support blocks optimally (especially putting the outermost blocks as far apart as possible), it was not hard to mount all four bikes. The only downside is that the rack sticks out pretty far, and as a result it strikes the ground on speed bumps and sloped driveways. My setup is a Drawtite hitch mount on a Camry, so it must be a fairly common configuration. I even had a machine shop chop off two inches and tap a new hole, to use the available mount clearance and reduce how much it sticks out. I think the frequency of ground strikes is reduced, but it still happens.

Everything worked out fine!