The 2009 and 2011 model years of the Cadillac SRX are not within the same generation and so their hitch fits are not the same. The 04-09 model years were the first generation, while 2010 and later model years are within the second generation. Links to hitches for both cars are included.
You'll note that both 1-1/4-inch Class II and 2-inch Class III hitches are available for both cars. In general we recommend going with the 2-inch option because it will have a higher towing capacity, more... view full answer...
I have a solution for you, but there isn't an adapter available that would allow you to connect your 4 inch sewer hose to the smaller macerator hose to create an extension. The macerator hose ends aren't threaded; they are held in place with a metal clamp instead.
We do have longer macerator hoses that can either be used as an extension, or replace the original 10 foot long macerator hose that is included in the SewerSolution Macerator System for RV Waste Tanks # SS01.
For a 25 foot long... view full answer...
To flat tow a 2013 Cadillac SRX you will not have to pull any fuses. You will however need a tow bar wiring kit, braking system, and safety cables to go along with your tow bar and base plates. If you haven't ordered these already then I have the following recommendations for you:
Tow Bar Wiring Kit: Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit # RM-15267. This diode kit will allow you to use your Cadillac SRX's tail lights and wiring system while preventing feedback from your... view full answer...
The TST TPMS System # TST-507-RV-4-C can be used to monitor 14 tires. This system can support up to 38 tires total. The monitor will allow you to cycle thru all 14 tires. You will need to purchase additional sensors, as this kit only comes with 4. Additional sensors are sold in a 4 pack # TST-507-RV-S4 or a 2 pack # TST-507-RV-S2. view full answer...
The SMI Stay-IN-Play DUO Supplemental Braking System part # SM99251 is compatible with your 2016 Cadillac SRX. However, as you mentioned the stop light circuit on this vehicle will go dead while in tow mode. Therefore, in order to power the monitor light you will need to run the red wire from this to the blue wire that goes between the breakaway switch and the operating unit.
I have attached a diagram to help with this as well. view full answer...
Whether you have the Roadmaster BrakeMaster Braking System for RVs with Hydraulic Brakes # RM-9060 or the Roadmaster BrakeMaster System for RVs w Air or Air Over Hydraulic Brakes # RM-9160 you need to keep your breakaway system install on the Jeep Wrangler if you plan on still flat towing that vehicle. I reached out to my contact at Roadmaster who said that the breakaway kit is pressurized and so it needs to stay in a secured location and shouldn't be mounted on the air cylinder. If you... view full answer...
Yes, we do have a hitch for your 2013 Cadillac SRX. It is the etrailer Trailer Hitch item # e55AR. This hitch is custom fit and bolts to your Cadillac with included hardware.
I really like this hitch because it installs right below your rear bumper and has a matte black finish. Both of these functions really make the 2" x 2" receiver blend in well for a subtle look. This also helps you with ground clearance so you won't have to worry about bottoming out when going up or down step inclines.
To... view full answer...
Yes, the Thule Sidekick cargo box does fit the Thule WingBar Evo roof rack. The recommended bars are the 53 inch, part # TH711400 for silver or # TH711420 for black. Then use part # TH710401 for the Evo raised rail feet to mount the WingBars. view full answer...
There is a trailer hitch receiver that has a concealed crosstube for your 2015 Cadillac SRX, which is from Draw-Tite:
- Draw-Tite Max-Frame Trailer Hitch Receiver # 75682
As you can see by the accompanying photo, the crosstube of the hitch is almost entirely hidden, so only the receiver is showing. The center fascia panel will be removed so just a portion of the hitch is showing, with the rest of it hidden behind the remaining fascia.
I have added a link below to a video review for... view full answer...
If used with the # BX88297 adapter, the Blue Ox # BX1690 base plate kit is compatible with the Ready Brute Elite II tow bar.
To complete your towing system, you'd need safety cables like # RM-643 if you don't have them already, a taillight diode wiring kit like # RM-152-98146-7. Assuming your vehicle is at factory ride height using the stock tire size, the base plates will sit about 16-1/2 inches above the pavement. If this is more than 3 inches higher or lower than the receiver height... view full answer...
Yes, the correct 4-way wiring harness for your 2008 Cadillac SRX is the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector # C59236. view full answer...
I called Blue Ox to confirm this for you.
Based on the attachment point of the Roadmaster Nighthawk All Terrain, Non-Binding Tow Bar for Blue Ox Base Plates, part # RM-677, the Blue Ox KarGard Towed Vehicle Protector, part # BX8870, should work just fine.
I've linked to a video installation of the KarGard. At the 10-second mark, you will see the bolt of the tow bar that is to be removed to install it.
Looking at the review video for the Nighthawk that I've also attached, at the 44-second... view full answer...
You are correct the pictures are a typical photo and do not show the actual SeatSaver that will fit your 2010 Cadillac SRX with the seat back DVD player. It will just show the style of SeatSaver that is used for your vehicle.
I checked with Covercraft and their application guide list the Covercraft SeatSavers, part # SS2428PCTN, that you have referenced as the SeatSaver for your 2010 Cadillac SRX with the seat back DVD player. It also specifies that this cover fits your bucket seats with... view full answer...
The OutWay # TH65JV is a confirmed fit for your 2014 Cadillac SRX but it will not fit your 2006 Ford Mustang. If you would like a trunk mount bike rack for your Mustang then you will need to use a Saris Bones bike rack like part # SA805BL.
If you are really wanting a bike rack that you can use with either vehicle you will need to go with a hitch mount option instead. Let me know if you'd like to go this route and I can make some recommendations for you. view full answer...
Yes, the Demco Classic Base Plate Kit part # DM9518266 will require an adapter to use the Blue Ox tow bar.
The Adapter for Blue Ox Tow Bars to Demco Classic Base Plates part # DM9523034 is what you need to adapt the tow bar. This adapter only works with Blue Ox Aladdin, Aventa II, Aventa LX or Alexus tow bars. Please let me know if you have another Blue Ox tow bar and I can look into that further for you. However, you may consider replacing the tow bar all together especially since the... view full answer...
That's a nice thing for you to do for your son and I can help you get what you need.
For mounting hardware for the Space Case you can use Replacement Mounting Hardware 8870098; Yakima no longer makes replacement hardware for this cargo box but has previously confirmed to us that this hardware will work.
Your son will also need a roof rack that fits the factory rails that run front to back. For his 2012 Cadillac SRX I recommend an option from Yakima, which consists of the CoreBars # Y00421... view full answer...
I think what you are asking is if you can use a Husky Center Line Weight Distribution System like part # HT32218 with a Reese Weight Distribution Shank like part # RP3215 and if that is the case then yes, all of our weight distribution systems and shanks are cross-compatible.
If this is not what you are asking then please just let me know but Husky does not make trailer hitch receivers. I have also attached a help article which explains some of the common terminology used for towing items. view full answer...
As long as your Cadillac SRX AWD is between the years of 2004-2009 and it does not have the Sport Package fascia this Draw-Tite Max-Frame Trailer Hitch Receiver # 75174 would work for your vehicle.
I attached installation instructions and an installation video of this product for you to check out also.
To complete your towing setup you may be interested in the following products:
Tekonsha Wiring Harness # 118686
Ball Mount 1 inch Rise or 2 inch Drop # C45030
Hitch Ball with 2 inch Diameter... view full answer...
I checked with Rhino Rack and they have confirmed that their roof rack that they offer for you vehicle that consists of the Rhino Rack Vortex Aero Crossbars part # RRVA118B-2 and Rhino-Rack SX Series Leg Kit # RRSX100 will work on your vehicle and not interfere with the opening of your panoramic sunroof. view full answer...
I do have a bike rack that may work for your 2012 Cadillac SRX, the Yakima HangOut 2 Bike Rack - Trunk Mount - Adjustable Arms, part # Y02637. The three bike option, part # Y02638, will also fit your vehicle, but your toddler bike will not fit on the rack. The bike frame is too small and there is not a frame adapter to fit a bike of that size.
The HangOut 2 comes with the same QuickTrigger hub system, which will allow you to set your trunk bike rack to fit the shape of your trunk or hatch.... view full answer...
Go To Results