The MaxxFan Deluxe Roof Vent w/ 12V Fan # MA00-07500K referenced in your question fits a 14 inch x 14 inch RV roof opening, but the mounting flange itself measures 16-1/2 inches x 16-1/2 inches. This will refer to the footprint of the unit from inside your RV/trailer.
The actual vent that will mount above the roof of the trailer measures 22-1/2 inches long and 16-1/2 inches wide. When closed it will extend 5 inches above the roof and when open it will extend 9-5/16 inches above the roof.... view full answer...
The Thor Motorhomes have a big tire and the only hitch mounted spare tire carrier we have for it is the Roadmaster Hitch Mounted Spare Tire Carrier w/ 2" Receiver Opening item # RM-195225. This carrier holds 16" to 24-1/2" spares with any bolt hole pattern and fits a 2" hitch.
I have linked a review video below so you can see all the functions of this tire carrier.
The etrailer Hitch Mounted Spare Tire Carrier item # e98ZR you were looking at and other comparable spare tire carriers... view full answer...
In regards to the Curt Trailer Hitch Receiver part # C14048, the distance from the center of the front mounting hole to the center of the rear mounting hole is 17-1/4". The distance from the center of the mounting holes left to right is 31". I have attached a photo below with these measurements. Unfortunately, we don't have any measurements to the end of the flange.
If you're looking for a trailer hitch for an F-53 Chassis, I recommend a service body hitch like the Draw-Tite Ultra Frame... view full answer...
I am happy to help!
The width of the Curt Trailer Hitch Receiver # C15325 measured center of the left side bolt hole to the same center of the same hole on the right side measures 34-1/2". From the center of the furthest forward bolt hole to the center of the center bolt hole measures 4-7/8", and from the center of the center bolt hole to the furthest rearward bolt hole measures 9-1/2" as you can see in the included diagram.
I went ahead and included the link to the written instructions... view full answer...
I definitely have a photo of the dimensions for the Curt Trailer Hitch Receiver # C15845!
In the attached photo you'll see the spacing varies between 30" and 31" depending on which set of mounting holes you're looking at. view full answer...
Typically when you level an RV or a motorhome you don't need to have blocks or ramps under all the wheels.
I attached a picture that shows how the Hopkins Leveling Kit w/ Wheel Chock # HM08200 normally gets used if you were to need max height. It really is only geared for one wheel. You'd need additional sets of this for each wheel you needed to bring up to level. view full answer...
I've attached a little diagram displaying the dimensions of the Buyers Products Rocker Switch # 3373014187 below. If you need any other dimensions or have more questions just let me know. view full answer...
Your Ford F-53 chassis under your 2017 Thor Windsport 29M is rated for a maximum towing capacity of 5,000lbs. This means that even with an 8,000lb rated receiver you are still limited to only being able to tow 5,000lbs without risking damage to the chassis. To haul your Chevrolet Cruze I recommend finding a lightweight aluminum trailer. This will help to ensure you keep your total trailer weight below the maximum 5,000lb towing capacity.
To tow the trailer you will most likely need a... view full answer...
It depends on a few things as it's not a standard difference but typically an incandescent 1157 will pull around 2 amps whereas an LED like the part # CM93236 pulls around 0.2 amp. view full answer...
Good question, and it's actually pretty simple; running watts is the amount of wattage a generator can always supply, on a continuous basis. Starting watts is the amount of wattage a generator can supply for moments at a time in order to start up an appliance. So an air conditioner, for example, may need 1,800 watts at its initial start up, but just 1,200 to run.
The 4,500 watt Champion generator you asked about gives 4,500 starting watts and 3,500 running watts (when used with gas) or... view full answer...
The stainless steel braided supply lines for the Empire Faucets VF77CH-E RV Single Lever faucet which we offer as # EM55PR are a total of 18-1/8 inches long. view full answer...
According to Solara (Lippert), the correct number of turns to set the proper tension of their slide toppers like what # LC34FR fits is between 12 to 16 turns, so I'd consider 14 to be a pretty good happy medium. view full answer...
A 2016 Jeep Renegade Trailhawk can not be flat towed. You will need to use a trailer or tow dolly like the Demco Kar Kaddy SS Tow Dolly with Disc Brakes item # DM9713045. view full answer...
The total weight of the etrailer eDream Supreme RV Mattress # e67FR is 125 pounds. Most of this weight comes form the gel memory foam construction unparalleled comfort. view full answer...
There are two options depending on whether or not your Thor Delano has the front center floor air duct. I have listed them below:
With Front Center Floor Air Duct - WeatherTech Front Auto Floor Mat item # WT62YR
Without Front Center Floor Air Duct - WeatherTech Front Floor Mats item # WT26YV view full answer...
Based on the dimensions you mentioned the correct Lippert SolidStep you'll need is the SolidStep Manual Fold-Down Steps # LC791574. Both part numbers you mentioned are correct for your door's height but this is the one that is correct for the doorway width you have. view full answer...
The internal height of the boxes that come with the Yakima EXO Swing Away Storage System w/ 2 Enclosed Cargo Carriers # Y74ZR is 14-5/8 inches. The length is 51-11/16 inches and 17 inches wide. view full answer...
We may have an option for you, though the part you asked about is unable to be used in the rise position, it can only be used in the drop position. For flat towing, you can use a high-low adapter in the rise position, and can do so without being perfectly level; what you need is to be within 3 inches of level, as you can see by the diagram I added.
So with this in mind, the adapter with the most possible rise is 10-1/4 inches, and that will work if you are within 3 inches of being level:
-... view full answer...
Go To Results