Optronics Trailer Lights - STL116RB

8" x 2-15/16". Waterproof trailer light acts as brake, tail, turn, side marker, side reflex reflector, and rear reflex reflector. GloLight lens creates a solid light pattern with a smooth appearance. Stud mount. 3-Wire pigtail.

Features:

• Rectangular trailer tail light serves 6 functions
  • Stop light, tail light, turn signal light, side marker light, side reflex reflector, and rear reflex reflector
• GloLight lens creates a solid light pattern with a smooth appearance
  • Outer bands of LEDs function as tail light
  • Center LEDs act as turn and brake signal
• Sealed, waterproof construction is submersible
  • Light is designed specifically for boat trailers
• Durable surface-mount technology (SMT) construction of LED circuit board
  • Better withstands shock and vibration
  • Allows for improved heat distribution
• LEDs make great replacements for incandescent lights
  • Last 50 times longer
  • More efficient - provide brighter light with less power output
  • No bulbs to replace - no brittle filaments
• Durable plastic housing
• Red lens over white LEDs
• Mounts on surface of trailer with included studs
• 3-Wire pigtail
  • White is for ground
  • Brown is for tail lights
  • Green is for stop and turn
• DOT compliant
  • Meets FMVSS 108 and CMVSS 108 requirements for automotive lighting
• P2 rated

Specs:

• Configuration: passenger's side (right-hand side)
  • Driver's-side light (STL117RB) sold separately
• Dimensions: 8" long x 2-15/16" tall x 2-5/8" deep
• Distance between mounting bolts (center on center): 2"
• Diodes: 28
• Power draw at 12.8 volts:
  • Stop/turn signal light: 0.252 amps
  • Tail light: 0.135 amps
• Quantity: 1
• Lifetime warranty on LEDs

Sealed, Waterproof Trailer Light

The waterproof construction of this light makes it ideal for use on trailers that may be submerged, like a boat trailer. The circuit board is sealed, which means that water will not damage the diodes or circuit board.

P2-Rated Lights

A P2-rated light produces a 45-degree angle of light to either side of its centerline for a total of 90 degrees of coverage. This beam pattern can be seen straight on, but it cannot be seen clearly from the side. So this type of light can be used as either a side marker light or a clearance light, but it cannot function as both. If you need both functions, then you must install 2 separate lights on your trailer - one as a front or rear clearance light and one as a side marker light.

Surface-Mount Light

Surface-mount lights install flat against the surface of the trailer, so a hole does not need to be cut into the trailer for the light. This type of light is installed using a flange or bracket that has mounting holes. And mounting hardware is used to secure the light to the trailer.

STL116RB Optronics Glo Light Combination LED Boat Trailer Taillight - Right Side - Red Lens