Features to know about

Quick Bed Access: Tri-Fold Design

With the E-Series, you don’t have to remove the whole cover when you need to load up bigger gear. The tri-fold design lets you lift the rear panel for quick access or fold back two sections to open up two-thirds of the bed. When you’re done, just unfold it back into place and secure it—no parts to store or reattach later.

Simple Setup: Built-In Clamping System

You don’t need tools or extra hardware to get this cover on. The attachment hardware is built right in, and the spring-loaded tailgate clamps snap down tight without bolts or drilling. That means you can install or remove the E-Series in just minutes, leaving no rails behind once it’s off.

Reliable Weather Protection: Full Perimeter Seal

Rain, dust, and road spray are kept out by a full perimeter rubber seal that runs the entire edge of the cover. The vinyl top sits snug over a lightweight aluminum frame, creating a tight fit that sheds water instead of letting it pool. Your bed stays clean and dry even when the weather turns rough.

Tough but Lightweight: Vinyl over Aluminum Frame

The combination of a durable vinyl grain top and a reinforced aluminum frame gives this cover strength without adding bulk. Heavy-duty support bows span the width of the bed to keep the surface firm and well-tensioned, so it won’t sag or flap while driving.

Clean Look and Better Mileage: Aerodynamic Profile

Because it sits on top of the bed rails, the E-Series keeps a smooth, low-profile line that complements the truck’s shape. That streamlined design reduces air drag, helping improve gas mileage while keeping the truck looking sharp.