ProGrip Truck Bed Eye Bolt Anchor - 1/2" x 2" - Zinc Plated - 866 lbs WLL - Qty 2

Video Transcript for Review of ProGrip Trailer Tie Down Anchors - Eye Bolts - PG82ZR

Hi everyone, Steve here with etrailer. Today we're taking a look at the ProGrip Truckbed Eyeball Anchors. Now you're gonna get two of these. They're half inch by two inches tall and they're zinc plated rated at 866 pounds. Now what's neat about these is they're kind of threaded inside of each other. Once you follow the instructions and get this part here installed flush with your trailer bed or the decking, rather, when you're not using the eye bolts, you can screw in these plastic Phillips head keepers and these thread down in here, nice and flush.

And they're gonna keep out water, dirt, and debris. And then when you do need it, you can then screw back in the eye bolt into your trailer or wherever you got it fixed. I'm gonna spin it that way just to make it faster onto the trailer and have your tie on points when you need 'em. If you want to, you can certainly leave 'em in permanently. That's totally up to you.

But what's neat about this is it gives you that flexibility to remove these and have a flat decking again on the trailer truck bed, wherever you decide to put 'em. So again, folks, brake strength 2,600 pounds, working load limit, 866 pounds. You do need to drill a three quarter inch hole. And again, these are half inch thick up here by two inches tall overall, from the base here up to the top of the eye ring. So again, nothing, not counting anything below the deck, but just from here on up.

That's gonna wrap up our quick look together folks. I'm Steven, thanks for watching.