
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Thin factory jack feet are usually the first weak link in your camper's landing gear. When they bend or sink, these 9" steel pads swap in for the original feet, adding a wider footprint and built-in articulation for uneven ground.
If you've ever watched a factory pad start to curl at the edges while leveling, you already know the weak point. Thin stamped feet flex under load, and once they bend, the load shifts back into the jack leg itself. That's how minor deformation turns into long-term wear, alignment issues, and expensive hydraulic repairs.
These 9" pads are designed to replace Lippert Level Up pads (LC324269) and Lippert Titan foot pads on motorhomes and 5th wheels. Laser-cut from 1/4" plate steel and reinforced with six gussets, they're built to hold their shape when the weight comes down instead of flexing and fatiguing over time.
Campsites aren't all poured concrete. You back into what looks level, drop the jacks, and one corner always seems to settle differently. A rigid foot can force the jack to load at an angle, which adds strain where you don't want it. The integrated ankle pivots up to 10°, allowing the pad to adjust to slopes and uneven terrain. The leg stays aligned while the foot sits flatter on the ground, which helps the entire leveling system work the way it was intended. Instead of wondering if a soft site will leave you re-leveling in the morning, the jack stays aligned, the load stays distributed, and your leveling system holds its position overnight.
Soft soil, gravel pads, sandy lakeside sites, they all test small jack feet. A narrow pad concentrates weight in one spot, which can lead to sinking and shifting as the ground compresses. The 9" round footprint redistributes that weight across a wider surface area, reducing how much the pad presses into the surface below. The broader base gives the jack more support underneath, especially when the ground isn't as firm as it first looked.
It only takes one hidden curb, rock, or raised edge to put a jack system in a bind. When a rigid foot meets an immovable object, something's gotta give, and that 'something' is often your hydraulics or frame. These pads are designed to detach first, sacrificing the foot instead of forcing that shock into components that cost far more to repair.
RVpaws are designed to work with compatible SnapPad Xtra pads, combining the strength of reinforced steel with added grip and ground protection. If you'd like additional traction on concrete, gravel, or other campsite surfaces, compatible 9" round SnapPad Xtra pads (SP54FR, sold separately) install directly onto the RVpaws foot.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, everybody. Andy here with etrailer. Let's take a quick look together at these RVpaws V2 Replacement RV Foot Pads for your Lippert Level Up and Titan systems. So, this is going to be an upgraded replacement footpad kit for your RV's leveling systems, specifically as I mentioned, for your Level Up and Titan setups. So, these are going to fit right in without any hassle. And what makes these really useful is how they are going to handle real-world conditions.
The feet have a pivoting ankle that can tilt up to about 10 degrees. So, when you're parked on uneven ground, it's still going to sit flat instead of rocking or putting stress on your jacks. These also have a a wider base, so retrieving my ruler here, lining this up here just to show you. So, I hope you can see, you're gonna get nine inches of base here. So, this is gonna help spread out the weight.
That means if you're on softer ground, like dirt or gravel, it's gonna be much less likely to sink in compared to smaller pads. If you're wondering about the overall height of each pad, not including the hardware here, we're sitting pretty close, not quite two inches tall. Now, the construction is heavy duty. This is made from thick, quarter-inch steel with reinforced supports as you can see here. So, these are going to resist bending under load.
These are unlike your standard foot pads on your jacks. Those are typically thinner, and they're more apt to bend. That's gonna throw off your balance. So these will resist bending because of just how thick they are and the supports as well. Another smart feature is that this pad can actually detach if you hit something, which is gonna help protect your leveling system and RV frame from damage instead of transferring all of that force upward.
And then if you even want more grip or protection, these are compatible with Snappad Xtra pads. So, on your screen, I'm popping up the part number of the snappads that these will work with, and you can take that number and pop it in the search field of our website. That will take you to that snappad, and you can add that to your order if you so desire. But as you might know, snappads give you a little more grip and protection. They're made out of a rubber, so really nice add-on. But overall, these are going to be a sturdier, more adaptable foot pad that's going to give you better stability and protection when you're leveling your RVs, especially on uneven or softer ground. I think that's gonna wrap up our look today. I do hope that our brief time together was helpful for you. Again, my name is Andy. Thank you for joining me.
Customer Satisfaction Score:
97% were satisfied with this product
3% of customers were not satisfied
Ratings & Reviews
Do you have a question about this RV Jack Pad?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.










Christopher H.
8/14/2026
Really appreciate the detail on the installation and including the photo! Sounds like this was a simple replacement and is going to hold up well for you.