24" Long hose is often used as a jumper on tandem-axle and triple-axle trailers. Brass fittings won't rust and are easier to work with than stainless steel.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everybody. Andy here with etrailer.com and today we're gonna take a brief look at this D-Max two foot long rubber hydraulic brake hose. Now this flexible rubber brake line acts as part of your trailer's hydraulic braking system. It connects your hydraulic brake actuator to your trailer brakes when used with additional lines and fittings, which are sold separately. And this flexible design is going to make this hose perfect for use with foldaway trailer tongues, disc brakes and torsion axles. This rubber hose meets the DOT and SAE standards, and there are 3/16 inch brass male inverted flare fittings on either end of this hose.
And as you might know, brass is softer to provide a better seal than steel fittings. And lemme go ahead and straighten this out here just a little bit. Line this up here and get my tape measure. And I just want to confirm the measurements with you. So laying this out here so you can see this.
Measuring end to end. As you can see, we are sitting right at 24 inches long just to confirm that with you. And that inner hose diameter is 1/8 inch. Well, that's gonna conclude our brief look today. I do hope that it was helpful for you.
Again, my name is Andy. Thank you for joining me.
Customer Satisfaction Score:
98% were satisfied with this product
2% of customers were not satisfied
Ratings & Reviews
Got this for my boat trailer great replacement line. I have brakes again
Awesome I finally found some flexible brake lines for my truck. I'm definitely going to be ordering more from y'all. I have a 2001 Toyota tundra and your brake lines have helped me tremendously because before my truck was busting the metal break lines over and over.
Do not order this product. The standard fittings for 3/16 flared brake lines have 3/8"-24 threads. This has something else. I'm not sure what the threads are, maybe they're some metric thread that someone through would be close enough, maybe they were made with really poor quality Chinese dies, whatever the story, the end fittings would not thread into 3/8"-24 fittings, they would start and turn a few threads then jam. Yes, I'm sure it was the firings on the hose which were the problem. I tried multiple fittings from multiple sources which all worked together nicely. I even checked with some good quality US made 3/8" 24 taps and dies The fittings on this hose were the one's which were the wrong size. Also, the flares on both ends of the hose were damaged.
Got in a timely matter
Worked great nice quality and perfect fit. Thank you etrailer!
Great brake hose that runs down to the caliper. Fit my Wesco boat trailer perfectly.
Customer service was awesome! Saw I had a part that would take a couple of weeks to get, and they identified they had a substitute part in stock available for shipping immediately. Thanks!
It’s a perfect match for what I need to replace.
very nice 5 stars
Super fast company for ordering!!
Have used for multiple orders.
Fast shipping.
Great follow up.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.