Features to know about

Full Bed Access: Roll-Up Design

Many covers have to be removed or folded awkwardly when you need to haul something tall. With the Sentry, you just roll it up. The 3/4" thick aluminum slats are flexible enough to roll tight against the cab, and the attached safety straps keep it secure while you drive. It stays low enough that it doesn’t block your rear window or third brake light. And when you need every inch of your bed, you can take the whole cover off in seconds—no tools required.

Strong Protection, Soft Convenience: Hybrid Aluminum and Vinyl Build

This cover blends the strength of a hard tonneau with the easy handling of a soft one. The heavy-duty, leather-grain vinyl top is pressure bonded to thick aluminum slats, giving you a solid layer that resists dents, UV rays, and tough weather. It’s been tested to handle extreme temperatures from -40°F to 120°F. The blacked-out finish looks clean and uniform whether it’s rolled up or closed, and it’s strong enough to hold up to 400 lbs of evenly distributed weight.

Streamlined Style: Ultra-Low-Profile Rails

The side rails mount inside the bed and are angled at 15 degrees, so the cover sits just 1/2" above the bed for a clean, flush look. The low stance doesn’t just look good—it also cuts down on wind drag and noise while helping with fuel economy. Because the rails install inside the bed, you still have full use of your stake pockets for tie-downs and other accessories.

Secure and Simple: Slam Latches with Mid-Bed Locks

When the tailgate’s closed and locked, your cargo is locked too. The slam latches at the tailgate snap down to secure the cover, and additional latches at the mid-bed automatically engage for extra protection. The hard aluminum slats make it far tougher to cut or pry open than a standard soft cover, giving you peace of mind when you leave gear in the bed.

Quick Install and Smooth Operation: Self-Leveling Rails

Setup is straightforward thanks to clamp-on, no-drill rails that square themselves as you tighten them. That self-leveling design means the cover rolls evenly every time without binding or sagging. Hook-and-loop fasteners along the rails keep the edges tight in place, sealing out dust and water. Once installed, it opens and closes smoothly from either side using simple release cables at the tailgate.