Custom DK Fit Kit for 4 Rhino-Rack 2500 Series Roof Rack Legs - Naked Roof
This item does not fit your vehicle
2005 Chrysler 300
These items fit your vehicle
2005 Chrysler 300
To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
This custom fit kit lets you mount 4 Rhino-Rack 2500 legs to your vehicle with a naked roof. Clamps mount to legs with bolts. Includes 4 clamps and 4 pads.
Features:
Specs:
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today on our 2012 Honda Fit we'll be test fitting the Rhino Rack 2500 Series roof rack with the arrow crossbars measuring fifty inches long in silver, part number DA126. We'll also be using the custom DK clamps and pads for the Rhino Rack 2500 series roof rack systems, part number DK154. With our roof rack system assembled according to the instructions, we'll begin our test fit by opening our front doors. We'll grab our front bar and place it onto the front part of our roof. To ensure that we have this bar in the correct location, we need to measure 270 millimeters, or 27 centimeters, from the center of our door jamb to the center of our foot plate. We'll do this measurement on both sides to ensure that our feet are in line with each other. We can then use an allen key to tighten the allen bolt, which will secure the clamps around the roof line of our vehicle. We'll make our way from passenger side to driver side, tightening a little at a time so we don't lose our position.
With that secure, we can open our rear doors and grab our rear bar and place it onto our roof. To ensure that we have this bar in the correct location, we need to measure 700 millimeters, or 70 centimeters, from the center of our front plate to the center of our rear plate. We'll do this measurement on both sides to ensure that our feet are in line with each other and that our bars are parallel. Once we have it set, we can use an allen key to repeat the same tightening process that we used at the front. With everything tight and secure, we can go ahead an install our black plastic covers over our foot packs. That completes today's test fit of the Rhino Rack 2500 Series roof rack system using part numbers DA126 and Dk154 on our 2012 Honda Fit. .
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.