11-1/4"Wide x 10-5/8" tall x 2-1/2" deep, efficient, reliable tornado fan Improves gas mileage and boosts overall performance by maintaining proper airflow to your vehicle's radiator. Includes toggle switch for manual control.
Features:
Specs:
Whereas belt-driven fans use up power from the engine to turn, electric fans do not, thus removing any unnecessary load and increasing both fuel economy and horsepower. In addition, you do not have to worry about an electric fan's slowing down at low RPM, as many belt-driven fans do, so you are guaranteed sufficient airflow regardless of the vehicle speed.
Before purchasing an electric fan, be sure to determine the CFM (cubic feet per minute) requirements for your engine. And remember, engines that have been modified or vehicles often used for towing may require additional CFM. There is no limit to the number of fans you can install, as long they all fit appropriately and are mounted on the same side of your radiator so that they do not cancel each other out.
Two types of turn-on sources are available for this fan. The Derale Lighted On/Off Switch for Electric Fans (D16740) allows for manual control of your fan so that you can choose when to turn it on and off. Thermostatic controls, on the other hand, send a signal to the fan, directing it to shut off when fluid temperatures reach an appropriate level, thus saving power. Once the temperature climbs again and additional cooling is needed, the fan is automatically turned back on. Thermostat switches can be single-stage with pre-set temperatures - D16735, D16738, D16739, D16720 and D16721 - or adjustable - D16778 and D16779.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to take a look at the Derale 10 inch Tornado Electric Fan with the toggle switch. This 10 inch reversible tornado fan will improve your gas mileage, boost your overall performance by maintaining proper air flow to your vehicle's radiator. This fan can be mounted on either side of the radiator as either a pusher or a puller with no loss of air flow. It comes from the factory all set up as a puller application but if you need to change it to a pusher application, what you need to do is unbolt this, remove the fan, flip it over, reinstall it on to the motor shaft and you're ready to go. If you notice this fan has a nice ultra low profile design for tight applications. It does use an ultra quiet patented skew blade design as you can see. It has the six skew blades on it.
This part will come with everything shown here on the table. It includes the electric fan assembly, the fan mounting kit, the lighted toggle switch right here with the hardware to install it, 20 amp fuse with the installation hardware and a nice set of detailed instruction that will show you how to install it on to your vehicle. A few specs on this fan, the maximum cubit feet per minute it moves is 650. Power draws a low 5.3 amps and I want to give you some dimensions on it. The width from this edge to this edge is going to be right at 11 1/4 inches. The heighth from the bottom to the very top is going to be right at 10 5/8 inches and then the depth of the fan from the front to the very back at the farthest point is going to be right at 2 1/2 inches deep.
The fan itself is a 10 inch diameter fan and the depth of just the fan is 1 1/2 inches deep. That should do it for the review on the Derale 10 inch Tornado Electric Fan with the toggle switch.
These fans are made in America that means a lot to me.service was great thanks to Cathy.
After a year it's still working fine
installation was simple came with all said parts and both work great.
The quality of 500CFM Derale 8" Tornado Electric Fan appears to be good. The build quality is solid and it pulls a lot of air plus it's quiet. Time will tell how long it will last. Also I would like to emphasize the amazing service and delivery I received from etrailer. Very happy with my purchase and experience.
Installed just as advertised. Installed it using the single stage relay/thermostat (#16735). Car is a classic (1965), so plenty of room to work, took about 3 hours. Hardest part was deciding how to run/hide the wiring for a clean look. I broke one of the install pads, but extras can be obtained (#13001), about 6$ or so. Came on/ went off just as expected. Good product! Barry.
I installed the 5 inch fan on transmission cooler located behind the seat, and I used your 10 inch fan on the radiator. Both are perfect for this cummins diesel turbo charged rat rod. I like your product and service.
The product is exactly what I ordered. Customer service is excellent - I was kept informed of a delay in the shipping of my order. Very good service.
Works well. Did not need any of the parts in the installation kit. Should have bought it without them. The service and support by etrailer.com is exceptional. I have bought a lot of parts for my van conversion to an RV. Your company has done the best job handling the transaction and is far better than anyone else. You have your act together!
First off, I am truly impressed with etrailer's extensive info and product demos they offer on their website. I have purchased several items from etrailer and have never been disappointed. And shipping is fast. Regarding the Derale electric fan It works great to this day. But at etrailer and never look back.
My 1990's-vintage garden tractor had a hydraulic cooler crammed into the engine compartment, so I remotely located it and am now cooling it with your Derale 7" Tornado Electric Fan. It's working great! It will be so much easier to service the system. Your website did a fantastic job describing the fan, and ordering/delivery was flawless. Thanks!
The fan fit in there perfectly, I’m glad you guys had the info of this fan online! It was perfect for the cooler! It is install to where it pulls the air into the trans cooler and pushes air thru my condensor radiator, it is doings an awesome job! I would give you guys 5 stars but the cable wasn’t long enough, specially when three connections need to be on the back of the switch. I also wish you guys would have added the 25 amp fuse that the instructions asked for. Luckily I had a fuse and some extra cable laying around to make it work. I am happy with the product and it works like a champ.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.