Need a better fit for your door setup? This angled entry door holder uses a metal plunger and rubber socket to keep your door in place. The angled design helps with alignment, making it easier to hold your door open when you need it.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everyone. Steve here with etrailer. Let's take a look at the RV Designer plunger and socket entry door holder. It's an angled version, four and three-quarter inches long in a nice zinc material. So folks, that zinc is gonna make sure it's not gonna rust or corrode on you anytime soon. And you do have the socket and plunger assembly here.
So as you know, this will be mounted to one side, this will be mounted to the other. And then when the door closes, this will hold it in place. And this, again, is four and three-quarter inches long, and you get the four screws for installation. Now a lot of people don't realize you can just buy this rubber plug as a, or rubber socket, rather, as a replacement item. So maybe you have one of these that's worn out.
You don't have to buy a whole assembly. We do sell these separately, so make sure you check that out if that's all you need. But if you wanna just get a whole new assembly, obviously we got that too. We got you covered either way. it's a real quick installation.
You get the four screws included. That's gonna wrap up our quick look together, folks. I'm Steven. Thanks for watching.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.