Need a compact light with easy control? This LED puck light features a push button on and off switch and delivers bright, even illumination in a low-profile design. It installs easily and works great for everyday lighting needs.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everyone, Steve here with etrailer. Let's take a look at an RV Designer 12 volt RV LED puck light with push button. Now this is a surface mount 3-1/4-inches diameter. I did go ahead and pull off the cap here so we can go ahead and shut this off. Then you can see all the little LEDs in there. And then again, whenever this is installed, you'll simply clip on the frosted lens cap here.
So we go and get that pushed into place here. And then again, when you push it to turn it on, you're gonna have ample light. So let's go ahead and zoom out and then I'm gonna go ahead and turn off my overhead through your lights so you can see just how bright this is. And then zooming in, same thing, super bright. And then I can somebody push the center button, turn it off or on.
And I do want to go ahead and turn back on the studio lights here and shut this off. And then we can get a better look at the light again. So as I mentioned, you got that frosted lens cap here. And again, this measures 3-1/4-inches. You got the two wires on the back.
And as you can kind of see here, this literally just kind of clips into place, snaps into place. Whenever you're done installing the main part there onto your wall, wherever you're mounting it. So a pretty cool quick little install. It's gonna be about 308 lumens with only 3.5 watts of power. And that's gonna wrap up our quick look together.
I'm Steven, thanks for watching.
Ratings & Reviews
Easy swap
looks like a better part than factory time will tell.
Cheap 1/2" smaller than OE,small on/off button hope it works.
Haven’t installed. Hooked up to 12 volt battery and appears very bright
Good replacement for the OEM light in my Lance trailer. The mounting holes don’t line up perfectly with my OEM, but works great. Easy swap, and looks great.
Very professional, everything delivered as described
These lights were easy to replace. Used old flush mount with spring flip latch holder to pop rivet them to it and it looks great. Now I can turn it off when not needed!
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.