Video Transcript for Review of the Clamp-N-Carry Chair Rack for Standard RV Ladders

Today we're going to be taking a look at the Camco clamp and carry chair and bike rack for standard RV ladders, part number CAM51430. Securely hold a bike or up to four chairs with the Camco clamp and carry chair and bike rack. It simply clamps to your RV or camper's ladder, giving you the support you need to carry up to a hundred pounds. When not in use, the arms swing out of the way so you still have full access to your ladder. It's made out of a glass-filled, nylon construction so it's going to resist UV rays, and the zinc-plated hardware is going to resist rust and corrosion. It's going to fit standard one inch diameter ladders, or 7/8 inch diameter ladders with included adapters.

It has the combinations to pass a padlock through. We recommend Masterlock part number ML4680DNKL. Now that we've got all the features, I'll go ahead and show you how to get it installed. Now we've already got our left side installed. The right side installs the exact same way. The first thing we can do is we need to take apart our clamp.

We'll take our included tool, and we'll just loosen it up until it comes apart. We can set it in place. We want to make sure we're lined up with the other one. We're going to set it on top of a rung just as you see it here. We'll bring our plate back in. When you install these, you'll want to be sure that you install them that way when you put the knobs in, they're going to be on the outside.

With it in place, let's go ahead and get our hardware started. Once you get everything started, you want to be sure and tighten everything down evenly. We'll go ahead and load up. First, we'll show you how to load up a chair. First thing we need to do, open up our latches, raise them up.

Then we'll just bring our chair up and set it in place. Let's go ahead and get our straps setup. We can take off the clip end of our strap, bring it around, and then we'll put it through this buckle here, and do the same thing over here. Now we can bring both sides around our chairs, we'll run it through the clip, and now we can connect both ends, and then pull it tight. As you can see, with that being done, it's going to prevent our chair from moving around or flapping in the wind. For our bike, we're just going to rest it in place on our seat post tube. You want to be sure that the tires are facing in. Once you've got it in place, go ahead and close it up. For our strap, we'll just run it the same way. This is going to prevent our bike from moving around while we're on the road. That's going to complete our look at the Camco clamp and carry chair rack and bike rack for standard RV ladders, part number CAM51430.