Lippert RV Awning - LC26DX

Replace your RV's old or damaged awning roller and fabric with this heavy-duty assembly. Fits Edge and 2000 series 8' power awnings with a built-in LED strip. Installs more easily than replacing just the fabric.

Features:

• Awning fabric and roller assembly with built-in LED light strip replaces the old or damaged fabric, roller, and LED lights on your RV awning
  • Pair with your Edge or 2000 series support arms to create a complete awning
• Heavy-duty, durable fabric is made with premium 13.5-oz vinyl
  • Cold-crack tested to -25 F
  • Heat-welded seams prevent leaks
• Black roller tube comes with fabric pre-installed
  • Black Fade fabric starts black on the RV side and transitions to white
• Simple installation with included hardware
  • Roller tube easily slides onto the head of each awning arm
  • LED lights hardwire to your existing light switch
  • Awning rail (LC715217 - sold separately) required to attach fabric to RV

Specs:

• Application: Edge or 2000 series 8' power awnings with an LED light strip
• Dimensions:
  • Fabric width: 8'
  • Extended length: 7' 6"
• Warranty:
  • 1-Year limited on awning roller
  • 5-Year on fabric

Note: You must already have the switch from kit LC674282 or LC674283 to use the LED lights.

To determine what size roller and fabric you need, measure from the center of your awning's left arm to the center of its right arm. You can also measure the width of your old roller and replace it with a roller that's the same size, but measuring the distance between the two arms will give you the most accurate dimension. Do not order based on the old fabric width, as it will be too short.

Can You Just Replace the Fabric on an Awning?

Can you replace just the awning fabric without the roller tube? The answer is absolutely yes - but do you really want to? To replace just the fabric on your awning, you will have to disassemble your whole awning anyway, just like you would if you were replacing the roller and fabric assembly. When you get your new roll of fabric, you will have to unfold it and let it lie out for a good while to get rid of the creases. Then you have to painstakingly feed the fabric into the roller tube and then into the awning rail. Reassemble your awning back together and you will have to extend and retract your awning multiple times and tweak and tug at it to try and get the fabric centered and wrinkle-free between the roller and the rail.

If you get the roller/fabric combo right from the get-go, it's going to make it so much easier. You just have to feed the other end of the fabric into the awning rail and reattach the roller to the heads on the awning arms. Roll it in and out a couple of times to get the fabric even and you're done. Save your weekend and get the roller and fabric kit.

V000574501 Replacement Lippert Edge and 2000 Series Power Awning Roller Assembly - 8' Awning - Black Fade