Video Transcript for Complete Breakdown of the Replacement Namsco Wheel Cover

Jeff: Hello, everybody this is Jeff at etrailer.com. Today we're going to take a look at the replacement 16 and a half inch Namsco wheel cover for 8-Lug wheels for a quantity of one cover. Now this is a nice replacement wheel cover that'll fit over a wheel on the front or rear of your vehicle. You can see it is a nice low profile design, delivers a nice sleek look. It has a 304 Stainless steel construction, which is very sturdy and rustproof, and it has a nice mirror finish. It gives you a nice eye-catching shine on your wheels.

Now they do describe this cover as an eight hand hold design. And what they're talking about is these holes that go around the outside here. There's eight of them. So it's an eight hand hold design.Now the lug caps here that go over the lugs, they are removable. They're just held in by force clips right there or four little tabs and you can just pop those out to access your lugs if you need to.

Now they do use a snap in retention system, just wanted to zoom in to show you in close up a little bit. This ensures that the hubcap won't wobble or fall off, there's no hardware required. You can see all that does is just push onto your steel wheel and hold it into place. Now, one note I do want to mention is you want to make sure when you put this on that you line up the valve stem with this cutout. Right here, you can see how this is cut out in a section that's for your valve stem, where your valve stem goes.

So line that up with the valve stem and then push it on and attach this wheel cover to your wheel and that's cut out so it doesn't do any damage to your valve stem.This is for a quantity of one wheel cover, application we mentioned is for an eight lug front or rear wheel. Wheel diameter on this is 16 and a half inches. Now a couple of notes on this wheel cover, it does not fit Budd wheels or older split rims. Both of those are two old design wheels. The Budd wheels are stud pilot wheels that'll have tapered stud holes, and they use the lug nuts with a matching taper and the split rim wheels are the older design wheel that would have a large split ring around the wheel and it holds the tire to the wheel in case of a blowout.

Both of those again are older designs you don't see much anymore, and these caps will not work on those, but they will work on all the other ones. But that should do it for the review on the replacement 16 and a half inch Namsco wheel cover for 8-Lug wheels.