Replace a missing side plug on your Lippert Power Tongue Jack V2. Push-in rubber cover (1-3/8" OD) seals the jack-head opening to keep out water, dirt, and road grimerestoring full protection in seconds, no tools required.
Features:
Specs:
Fits:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everyone. Steve here with etrailer. Let's take a look at our replacement side plug cover for the Lippert power tongue jacks version two. So folks, this is a direct replacement from Lippert for their side plug on that Lippert power tongue jack version two head. It's a simple pop-in or push-in rubber. You're going to install this in mere seconds, no tools needed.
And this seals across the hole back there to block water, dirt, road grime, et cetera, from reaching the motor wiring. Now this is made out of a nice heavy duty rubber. It's flexible and it is a 1 3/8 inch overall diameter with the inner plug here, that smaller one there at 13/16 inches in diameter. Well, folks, that's going to wrap up our quick look together. Quantity one, this is a replacement side plug cover.
I'm Steven. Thanks for watching.
Ratings & Reviews
Arrived sooner than expected, installed easily, perfect fit.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.