Video Transcript for What to Know About the Replacement Angle Cylinder for Fisher Snow Plow

Speaker 1: Today we're going to take a look at the replacement 1 1/2 inch by 12 inch power angling cylinder for the Fisher snow plows. Now this part'll replace the power angling cylinder on your Fisher snow plow; it does replace the Fisher part number 20117K and part number A3660.It does use a 1 1/2 inch diameter rod. So the rod right there, if we put a ruler on that, there's your 1 1/2 inch diameter. It's 12 inches long. So it has a 12 inch stroke with a single acting power angling cylinder. The base right down here has a diameter of 1 and 3/4 inches.

And the pin size, which are these two holes here that the pins will go in, the opening of that diameter is 1 inch.Now the center-center dimension from this pin hole to this pin hole, when it's retracted, like it is now, is 19 and 1/4 inches. And when this rod is extended out, would be 31 and 1/4 inches. The port type right down here is a 1/4 inch NPT size. The location of it is 90 degrees, and this part is made in the USA.That should do it for the review on the replacement 1 1/2 inch by 12 inch power angling cylinder for the Fisher snow plows.